Jump to content
SAU Community

Auto Swing Mirrors?

NeilC

By NeilC,
in Car Audio & Electrical

 Share

Recommended Posts

NeilC Contributor

NeilC

Posted
Posted

Am in the process of removing a cheap crappy alarm fitted to my R34 4 door and replacing it with a better one. Found the trigger points for the passenger doors ok and figured out how to trigger drivers door. On removing drivers door trim to check wiring i found this box wired into the mirror switch. From some research I believe it to be the module for the auto swing away mirrors. It had been disconnected but I would love to see if I could reinstate it. One side goes to the mirror switch and is plug and play. The other three wires however have me guessing. I split the box and they are marked on the circuit board as follows.

B+ (Straight 12v or Acc/On ?)

Earth (Obvious)

Sig (Trigger wire possibly?)

Its the signal wire that has me stumped. Am presuming that it was connected to the dealer/factory remote central locking to which I didnt get a remote for and was activated when you locked the doors either by key or remote. Anyone got any ideas?

post-114090-0-76317500-1372379106_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/427730-auto-swing-mirrors/
Share on other sites
NeilC Contributor

NeilC

Posted
  • Author
Posted

Sorted. Thanks Chris. you were right in that they take their power and signal from the keyless entry module. Power from pin three and signal from pin six. At first there was nothing. Had the switch on the door in the neutral position thinking that the module overrode the switch function. Wrong it has to be switched to the out position to work. A bit of buggerising around but is now working. Hit the lock key on my remote and the mirrors swing in. Turn the ignition on and they swing out. Cool little feature with no real use here except for the novelty factor I guess.

darksky34 Mentor

darksky34

Posted
Posted

Hand for tight street parking. Or in my case Redcliffe street parking where the idiots get within 2" of your car and destroy mirror housings.

yes. i once got back to my car with the driver side mirror facing outwards.....i was very pissed off but the person/car that did it was no longer there.

Got a Pulsar Grand Master

Got a Pulsar

Posted
Posted

Where can I get one of these little modules? I would love for my mirrors to swing in and out automatically.

Tommy_J <<<--------- This fella had some, I bought one from him but haven't installed it yet...

MrRx7s3 Mentor

MrRx7s3

Posted
Posted

Mine is a factory nissan accessory item. Read on another post that someone used a jaycar module for auto window rollup to do the same thing.

Hey man I've just been searching the forum to find it but I can't find it anywhere, would you be able to direct me in the right direction please, thanks.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Marek
      Hi everyone.

      By Marek · Posted

      Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Marek
      WGNC34 - floor mats

      By Marek · Posted

      Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • ARB26
      S1 Autech 260RS Wiring Diagrams

      By ARB26 · Posted

      I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...