Jump to content
SAU Community

Recommended Posts

to those waiting on licences to show up. you can ring cams and have them email or fax you a temp licence to use on teh day as I have done this in the past

call them on 1300 883 959

My bloody ASAA license hasn't showed up yet.

Might have to buy a cams license on the day.

Give them a call , if they have the application, they can email you a letter with the license number. ( have done this myself )

Edit: should have kept reading the thread. What Dave said.

are you guys still taking entries are there any spots left?

As with every official SAU:NSW event, unless you see us post that the event is full, then we're still accepting entries! :D

Me. Hopefully.

The F6 had it's front bumper ripped off by a truck, and is supposed to be ready to pick up today.

Fingers Crossed! (this is what it looked like last time I saw it :()

1272969_10153332509710301_1518799089_o.j

Me. Hopefully.

The F6 had it's front bumper ripped off by a truck, and is supposed to be ready to pick up today.

Fingers Crossed! (this is what it looked like last time I saw it :()

1272969_10153332509710301_1518799089_o.j

Dam mate! Hopefully you get that back soon.

And nice wheels lol.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...