Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

or just try Bunnings. You'd be surprised what you can find as quality bolts at very good prices.

Thought you were a smart man Ants, then you go and say something like that.

"over $70k spent" and it has a cut and shut VLT plenum, surely another $900 on a cpc plenum wasn't that much of a stretch.

Also "tomei everything in the head" can't find anything RB30e related on the tomei website.

"over $70k spent" and it has a cut and shut VLT plenum, surely another $900 on a cpc plenum wasn't that much of a stretch.

Had noticed that too, but Plazmaman cut and shut there one too for rb25 - good bit of kit ask Scott. I'd just buy the JPC. Would only buy car like that conditional upon dyno check first.

Tomei: I think it must be adapted from a 26. Not sure would need to pull the rocker cover. However, look at the wiring deletion and attention to detail in the engine bay, I don't doubt he's spent the coin.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
    • I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
    • Yeah, I would have said the same. It makes me suggest that there are other things wrong, such that the ECU is totally unhappy with the broken sensor. The only other thought here is that maybe it is shorted, which might cause a different issue to the typical "disconnected" sensor.
×
×
  • Create New...