Jump to content
SAU Community

Recommended Posts

Hi guys and girls, anyone have any ideas what could be causing my stagea to run rough? Sounds like it's running on 5 but tacho says it idles steady, it still makes boost but slowly, feels like it goes good once the boost kicks in. Just changed the plugs and coilpacks and all the plugs look the same, no fouling etc. Wondering if it could be fuel filter or boost leak or afms, or fpr? Just had fuel pump done too. Also has a bit of backfire on gear changes

Link to comment
https://www.sau.com.au/forums/topic/432543-help-rb26-sounds-like-a-wrx/
Share on other sites

Just because the tacho is stable doesn't rule out a cylinder missing. With car running disconnect one coil pack at a time, in no time you will know which pack/plug/part of loom is dodgy

  • 1 month later...

Ok guys, replaced the plugs, replaced the packs with splitfires and just put in a new coilpack loom, still sounds like it's missing and smells rich plus is very laggy and won't make full boost, could it be an injector?

Just because the tacho is stable doesn't rule out a cylinder missing. With car running disconnect one coil pack at a time, in no time you will know which pack/plug/part of loom is dodgy

Did you do this? Or just replaced stuff for fun? Narrowing it down to a cylinder would have helped you determine if it was a coil pretty easily.

I replaced things that seem to cause common problems so I don't have to worry about it again for a while. It used to come and go so I had ruled out mechanical problems as I would think damaged piston or cylinder would be more permanent.

If it is intermittent there is a good chance one or both of the AFM's needs re-soldering, there is a 'how to' around on fixing them if you do a search.

It could be an injector too, would be a good idea to get them cleaned and flow tested just to rule them out.

I was just pointing out that trying to diagnose such problems over the net is near futile. It always turns out to be something either very obvious or nothing that anyone thought of.

So tempted to put that in my signature.
  • Like 1

When I bought it they did a compression test and has only done about 5000k since then so no I haven't plus cause it was come and go I didn't think it could be that. Happened around when the alarm went in, imobiliser issue maybe?

Wouldn't surprise me if its an afm.

Another quick thing to do would be check over all of the I/C piping and joiners for a leak and vacuum lines too

Edited by Even_Flow

Pull injector plugs one by one until one doesn't make it any worse than it is already. Once you find the cylinder that is missing check the plugs/coils/loom for that cylinder.

Could even use a screwdriver to the ear to find which one is missing.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...