Jump to content
SAU Community

Recommended Posts

Was a good day, thanks to everyone involved in putting it on. Shame I had to head off halfway through, but I managed to get a fair few photos before I left. I'll hopefully have them up tomorrow, but here is one for now,

10321041_326011924214517_313511617256157

  • Like 1

Was a good day, thanks to everyone involved in putting it on. Shame I had to head off halfway through, but I managed to get a fair few photos before I left. I'll hopefully have them up tomorrow, but here is one for now,

10321041_326011924214517_313511617256157

my boyfriends brothers car :)

10271190_10202861917523694_1816050157646that was me on stock tyres for the rear…it is a drift pig it just slid everywhere no hand break needed lol and in the rain ohhh mama it was even more slippery lol it was so much fun yesterday :)

10271190_10202861917523694_1816050157646that was me on stock tyres for the rear…it is a drift pig it just slid everywhere no hand break needed lol and in the rain ohhh mama it was even more slippery lol it was so much fun yesterday :)

Great!

Being a paid-up member, you're entitled to register to come to our SAU Tech Arvo to be held on Sat 26/7/14 too.

It's about ECUs and it's free. There are 1-2 spots left.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sane enough. Remove the roof liner, because the acid will go everywhere.
    • Thanks guys, I really appreciate the help and experienced opinions.  I have spent a lot of my life working on boats so I'm pretty good with fibreglass. I'll take everybody's advice in here;  I'll cut a little more of the 2nd layer away as it's a bit crunchy rust and also it's sitting high now. Then I'll wire brush it all a bit to get off anything loose, then I'll soak the bejesus out of it all in rust converter. I'll make sure to get a little hose piece and feed it into all the holes and gaps between the roof layers. Then I'll fibreglass up the holes.  Then I'll get a pallet of filler and mix it with 3 buckets of hardener and hope that is enough to build up the roof corner.  Does that sound sane? Is one type of filler better than others for this?
    • My goals for it atm are to get it registered, respray and some mild power gains eventually... I picked up the car from an elderly gentleman near the border of NSW and VIC, its honestly a bit rough and looks like its been driven on a farm (because there was so much dirt underneath). Last week I dropped the subframe and emptied the old fuel out + added a new fuel pump (think the old one went bad from old fuel). Now I'm onto fixing a coolant leak at the rear of the engine + adding a new radiator as the old one is corroded. After that i have a new bumper, coils (as the old were leaking) and lots more
    • Welcome buddy! Plenty on here and YouTube. What are your plans for it? Good luck with the Rwc and Rego bud!
    • Love this so much! Please post a photo when you have a bike on the trailer.  I was a little bit worried about having a tow bar on the Skyline, but having it hidden behind the number plate is genius
×
×
  • Create New...