Jump to content
SAU Community

Recommended Posts

I hate the drive accross the Hay plains, but have done it 4 times within 12 months lol. The sheep sheering station is a good spot for lunch. Make sure you fill your tank b4 leaving hay if heading to SA lol

Link to comment
https://www.sau.com.au/forums/topic/449467-hay/#findComment-7403313
Share on other sites

Aaaahh "tornado": predecessor to the roundabout!

Going to Mildura then Genelle?

Not sure it's in our area terry,but I would like to go there.

Been around the riverina this time it's beautiful out here long paddocks of green and gold. :-)

Link to comment
https://www.sau.com.au/forums/topic/449467-hay/#findComment-7403859
Share on other sites

Yah ill drive the Sydney to Adelaide route again one day. Last time i did the 17.5 hour drive in 1 go with only petrol stops. On the way home from Adelaide 8 months later i did the same trip and went home through Bathurst. Even after 13 hours of driving i took the time to detour and take a fully loaded R33 packed with all my stuff around the track haha.

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/449467-hay/#findComment-7404698
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Despite the level up question, actually I do know what that is....it is a pressure sender wire.  So check out around the oil filter for an oil pressure sender, or maybe fuel pressure near the filter or on the engine. Possibly but less likely coolant pressure sensor because they tend to be combined temp/pressure senders if you have one. Could also be brake pressure (in a brake line somewhere pre ABS) but maybe I'm the only one that has that on a skyline.
    • Pull codes via the self-diagnosis procedure. As far as I can tell this is just a sign of transmission issues but not a code unto itself.
    • Hi All, putting the engine back together and everything is perfect except have this plug left over.. any ideas what it is for and where it goes? Is on cold side under the intake plenum *note not a stock plug, as everything has been modified Cheers
    • Sounds like a misfire. Check fuel pressure and don't even think about going into boost while it's like this unless you enjoy engine rebuilds.
    • Just. Gasping. Here. Just. Gasping.
×
×
  • Create New...