Jump to content
SAU Community

Recommended Posts

Hey guys I think I have found the cause of my car running rich all the time and eating fuel, can someone please confirm this... (ps I'm running a Power FC)...

So as I take it the actual full tune comes on at 80+ degrees celcius is this correct?

Well my car is barely ever over 80, normally sits around 75, if I give it quite a fanging it gets to 82 then as soon as I drive normally again it goes back down to the 70's range, would this be the cause?

Second question, if this is the cause... would it be because my water temperature sensor is faulty? or is my car just cooling way too much (which I highly doubt) all of the cooling system is still standard, stock radiator, fan, shroud... it's even got a front mount at the front of it which should block some of the cooling so I'm stumped...

Thanks for any help in advance, thanks.

Most likely the thermostat is stuck open.

You can check the ECU's temp sensor. It has a defined resistance at every temperature. Just look up (google) what it's supposed to be at the temperature it will idle at. Then just compare the measured resistance against what the ECU says the temperature is.

Edited by GTSBoy

Well when I go into settings and then water temp correction, 80+ is at 1.00 - 1.00 and the rest eg 50+ are higher so I'm asuming its to put more fuel and and advance timing?, probably does have a nismo thermostat, never really checked since I bought the car, will check it out tomorrow and also write down the actual figures for 50+ etc, thanks.

Most likely a Nismo thermosate, same issue I'm having ATM, the base map on my ECU start coolant multiplier from 75deg escalating as the temp gets colder on the scale, I have to change that as my car sits right on 70deg daily driving and gets upto 76-78 on the track due to the manual clutch fan starting to kick in

you are correct in your analysis that the PFC will assume a base of 1.00 at 80deg water temp +

you can either diag why your water is too cold or simply edit the 50deg+ correction and match it to the 80deg setting.

just be sensible with the car when it gets to around 50deg and ensure its properly warmed up before you flog it

Well I'll try adjust that and just put the 50+ at 1.00 - 1.00 correction and see how that goes coz I feel silly taking a nismo thermostat out and putting in a tridon or something haha lol... if I don't notice much difference then I'll change the thermostat aswell... i did also notice that it always idled a little lower and more power when I do get it to over 80 degrees lol and always wondered why... I will let yous know how I go both with power and fuel consumption.

Throw the Nismo thermo in the shit can where it belongs. Never could understand why anyone would want a colder thermostat. Worst bandaid EVAR!

Probably for track to have more flow? Beats me dude.

Why is this hard to understand ?

Having an engine that runs a little bit cooler is not a bad idea, especially when that coolant is running through the head keeping the combustion chamber temps down a touch

The only problem is fitting them to engines where the ECU can't be adjusted to run properly with them

Engines run better when hotter due to their tune, if your engine has been tuned to run at 85 deg with the engine temp multiplier starting at 80 deg and increasing down the colder scale then you try and run it at 70 deg then no wonder why it runs worse, set it up to run there and tune to run there and it will run there perfectly fine and further away you are from the detenation threshold, obviously you can't run an engine hard at 20deg but 70deg + would make no difference if tuned properly

How about putting a nissan thermostat in?

It may be that you have a normal thermostat and its not functioning properly. Wouldnt hurt to change it out. Only have to drain the coolant, take the 3 bolts for the thermostat housing out and change it

Fresh coolant wont hurt

New thermostat should only be $30 or so. Worth doing if you dont know when it was last done

Yeah I'm going to be doing that... been wanting to change my coolant for a little while now... last time coolant and thermostat were changed was when I had the car imported in 2011 and got the timing belt, water pump and all that done about 30000kms ago... what coolant do you guys recommend? Atm it's got some kind of purple coolant? I think it may be royal purples coolant? From what I've checked out so far I like the look of penrites coolant... although never used it before and unsure, what do you guys use and every how often do yous change it, thanks.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The issue now is the 'fuel cut' while driving, and when it happend, it does not stall. This, I did not test the fuel pressure while driving as I cannot with a fuel pressure gauge. I do have Nistune logs, yes. I have also replaced the MAF Sensor.   Also related to the FPG Fuel Hanger – I just realized that I need a Deutsch Crimp Tool to crimp some cables for the FPG Fuel Hanger. Need to purchase additional cables as the kit only included 2, which are for the float. FPG is has not responded to my emails so far after purchasing. I thought about taking it to someone and having it done professionally, but I am reluctant since everyone I took it to messed up in some way.  
    • There's a good German place in Brisbane if youre up for the drive 😛
    • The German place in Cabramatta was rock solid, fresh pretzel cooked to order back then. Then it went all quiet, after all the poker machines were removed, then I believe it closed for good. I did drive past the other week and noticed outdoor lighting a big screen, but no idea what is there now.  
    • Yeah I suspect even if you hold airmass per cycle/cylinder constant if you get too far away from stock you're still going to have problems running the factory tune within the bounds of the factory load scale. Cams, different displacement/rod ratio, etc. I'm just lucky that the GTIII-SS with wastegate boost + CA compliance cats is pretty much equivalent to stock turbos. When I have actual space I can finally get it tuned and modify the fuel system for flex fuel to 100% handle any detonation concerns when cranking the boost to whatever those dinky turbos can put out.
    • I would say no, why, because my daughter, who also lives in Goulburn, hasn't recommended us going there Pity, as we miss all the German joints around in Sydney, actually, the restaurants are the only thing I really miss about Sydney, and a special mention to Ishibanboshi at Bondi Junction, their Kara-age Don is heart cloggingly deliciousness (always added a special boiled egg...or 2) 😋 
×
×
  • Create New...