Jump to content
SAU Community

Recommended Posts

I am parting out my r32 sedan, most parts available, but not the motor. Located in Newcastle, not going to list everything write a reply, or SMS 0414545301 for a quicker response. post-132714-14212066727002_thumb.jpg this is the car, so if you wanted something from drivers front, you out of luck.

Link to comment
https://www.sau.com.au/forums/topic/452700-wrecking-r32-gtst-sedan4-door/
Share on other sites

post-132714-14212324039971_thumb.jpg. Speedo surround $30

post-132714-14212324566616_thumb.jpg. Drivers window switch $20

post-132714-14212325145468_thumb.jpg. Centre dash surround $20

post-132714-14212325847784_thumb.jpgpost-132714-14212326036196_thumb.jpg. Seats $30 eachpost-132714-1421232647875_thumb.jpgpost-132714-14212326693046_thumb.jpgpost-132714-14212326947516_thumb.jpg. Doors including glass & window motors $80 each not including inside trim, post-132714-14212328109595_thumb.jpg. Rear bar $60

Tail lights $30 each

Boot $50 post-132714-14212329130923_thumb.jpg. Plenty more parts, car was complete at time of accident. Will post more photos as the parts come off.

Looking for:

- Centre Air Con Vent

- Drivers side pillar plastic panel (front section where tachos usually go)

- Passenger side rear pillar plastic panel (between back window and back door)

- Passenger side front inicator (providing its semi amber)

Poor little car :(

Edited by aussiebooster

Aircon vent has some broken bars on one side, other side is good.

post-132714-14213025951243_thumb.jpg. A pillar trim has cracks and a screw hole but sits in there how it should

post-132714-14213026834585_thumb.jpg. C pillar trim was in process of being fixed, has been coated with fibreglass, so it's very strong now, just needs a sanding then re covering. post-132714-1421302804236_thumb.jpgpost-132714-14213028263623_thumb.jpg I trial fitted them as is, & they fit good, just need to be sanded back abit, as adding the vinyl will make them to thick. $10 each or If you want all of it $20

  • Like 1

Drivers sun visor and driver/passenger kick panels with flare holder?

post-132714-14219163549118_thumb.jpgpost-132714-1421916373967_thumb.jpg. Drivers kick panel has a hole & missing insulation. Both have minors scratches. Passenger $15, drivers $10.post-132714-14219165149463_thumb.jpg. .jpg]

Drivers sunvisor, needs a clean $10

post-132714-14219165564255_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
    • Yeah - I mean, go the other way. Smaller range. Not larger.
    • To re-cap, I bought: https://www.alibaba.com/product-detail/Lsailt-8G-Infiniti-Q50-Q60-2014_1601171829627.html?spm=a2756.trade-list-buyer.0.0.2cd476e9FTIlKE As you can see, if I bought 20 it was $653, but I bought 1 so it was $1,170. I was very tempted to buy 2 and resell 1 at 25% cheaper. @MBS206, I am not sure if they do a Kluger one, here is their list but it might be there under a global model name: http://www.lsailt.com/product/android-interface?page=1 Keep in mind these full android replacements have basically all the bits a phone does (cpu, ram, storage, wifi, bluetooth, usb interfaces) other than a screen (it uses a host), thus the $800+ cost. Android Auto screen mirroring is MUCH cheaper as it's just a cut down shell, input mirroring and output mirroring BTW I also need that "screen off" feature, it is much harder to see wildlife even if a dash is reasonably dark. Both the Fuga and V37 have display off buttons for night use, they just come back on for a second or 3 if you interact with it, eg skip a song.
×
×
  • Create New...