Jump to content
SAU Community

Recommended Posts

3 hours ago, z00key said:


Not sure of the build up, could be from acid rain in japan?

Anyone up for a antilag supercruise in Collie later in the year? 

 

basically $130 for almost all day unlimited use of the track. No drifting or standing burnouts but everything else is fine. next one is May but i can make it. hoping to make august or october

  • Like 1
1 minute ago, TiTAN said:

Have you tried using a razor on the stains/build up? Same way you would tackle bad build up on a glass shower door/partition. Needs to be fresh and sharp.

yep agreed. 

 

thats how i clean the glass on my aquarium when its really dirty

Ok, New Windshield is on, It came pre-tinted which was nice. Looks much better than the last one.  and the Drivers Side door is fixed.

All but he charged me $603, and JapWreck charged me $125 for the window (which was the wrong window and I had to go back and get it swapped).

I played Tetris in my garage, moved a bunch of shit around etc... Now I can *just* barely fit the skyline in *if* I climb out through the passenger door

  • Like 2

Yeah the razor blade was 1 of the 1st things i tried with no change at all. Tried barmans friend, vinegar and baking soda, all sorts of Polish and all thats worked has been mothers water spot remover and a heavy duty buffer. As for track time i have never done it but could be keen.

  • Like 1
1 hour ago, Manne said:

Ok, New Windshield is on, It came pre-tinted which was nice. Looks much better than the last one.  and the Drivers Side door is fixed.

All but he charged me $603, and JapWreck charged me $125 for the window (which was the wrong window and I had to go back and get it swapped).

I played Tetris in my garage, moved a bunch of shit around etc... Now I can *just* barely fit the skyline in *if* I climb out through the passenger door

take care of it!!

  • Like 1



  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...