Jump to content
SAU Community

Recommended Posts

Now that we've gotten in the extended oil sump for the new RB26 that's going into my R32 I'm trying to figure out what parts we'll need to swap the front diff to the new pan. Can anyone tell me if there's a rebuild kit or install kit for the RB26 front diff and where to get them?

Thanks in advance for your help.

Now is the time to replace it with a Quaife LSD

http://www.sau.com.au/forums/topic/440091-rebuild-gtr-front-diff/

but if you decide to keep the open diff you can just put new seals in or go to town with all new bearings. I have a list of the bearings with Nissan Part numbers but I can't remember what modfel GTR they fit. If you quote just one part number to a Nissan dealer they should be able to tell you.

post-49463-0-93291900-1451778245_thumb.jpg

Front diff bearings and seals text.doc

  • Like 3

Now is the time to replace it with a Quaife LSD

http://www.sau.com.au/forums/topic/440091-rebuild-gtr-front-diff/

but if you decide to keep the open diff you can just put new seals in or go to town with all new bearings. I have a list of the bearings with Nissan Part numbers but I can't remember what modfel GTR they fit. If you quote just one part number to a Nissan dealer they should be able to tell you.

Thanks for the info! I'm not sure my budget has room for a front diff upgrade currently but I'm definitely considering it.

Doing mine at the moment, that picture shall be useful for me also, thanks.

Its a hard one with the diff upgrade if the budgets are marginal. It is a big chunk to add do your budget, but then again its another few thousand bucks to pull the engine to do it again in the future.

What are you doing with the car?

Circuit, street (runs or hills) or drag?

How much power?

Either way, change it now.

If it's anything that is going to involve RPM launches - so drag, and over 300rwkw/400rwhp... Then you absolutely MUST change it now. If you've spend big $$$ on a after market sump, you do NOT want the stock front diff blowing as it will take out some/all of the front sump if it fails badly enough which is anyone's gess. It happened to me and a few others over the years, so by spending now and doing it right, you'll thank yourself.

Its not "so much" needed for circuit but honestly, the improvements you get from doing it are IMO, one of the best value vs gain mods EVER. I've said it before that if I had my time in a GTR again I would do the following

- Small turbos/basic 300rwkw setup.

- Diffs, both

- Transfer Case

Rather than rebuilding motor and doing for 550hp+ as the driving experience/speed of the car is just so greatly improved it's outta this world levels of difference.

I would say Nismo for Drag and Quaife for circuit seems to be the consenses. That said I used my Nismo to blistering effect in 80-120km/h motorkhana based stuff, suited my driving style.

  • Like 2

Dont forget that most aftermarket diffs are a little larger in casing size and wont fit into the front diff case without some grinding in the right areas, best done when its all apart when its easier to get in there with a die grinder and to clean out all the alloy shavings.

We went drag direction and installed a Cusco setup as a one way diff.

But yes, 100% - you will NEVER regret a front diff upgrade - as long as you have done the rear.

Simple some of the best mods you can do to a GTR if you are aiming to enjoy the driving of it

  • Like 1

But yes, 100% - you will NEVER regret a front diff upgrade - as long as you have done the rear.

Simple some of the best mods you can do to a GTR if you are aiming to enjoy the driving of it

Even without doing the rear, it was one of, if not the best mod I did. Front, rear, transfer was my order. It just gets better every time!

Thanks for the replies everyone. I ended up getting a Nismo LSD. Although the Quaife is the better unit for road course no one carries it here in the US and at over twice the price of the Nismo I couldn't justify it anyway since my R32 will mainly be a weekend/show car and will probably only see the track on a very rare occasion. Either way, I figured if the Nismo was good enough for their JGTC cars then it'll do fine in my R32 lol.

  • Like 1
  • 3 weeks later...

Thanks for the replies everyone. I ended up getting a Nismo LSD. Although the Quaife is the better unit for road course no one carries it here in the US and at over twice the price of the Nismo I couldn't justify it anyway since my R32 will mainly be a weekend/show car and will probably only see the track on a very rare occasion. Either way, I figured if the Nismo was good enough for their JGTC cars then it'll do fine in my R32 lol.

Look at my build for pretty detailed pictures. It should be noted that I cut my own shims, but buying factory would have been easier (beware there are a LOT of factory shims).

Here's a link

http://www.sau.com.au/forums/topic/447384-r32-gtr-build-in-usa/?p=7559306

Look at my build for pretty detailed pictures. It should be noted that I cut my own shims, but buying factory would have been easier (beware there are a LOT of factory shims).

Here's a link

http://www.sau.com.au/forums/topic/447384-r32-gtr-build-in-usa/?p=7559306

Thanks for chiming in. I saw your thread before and that's partly why I got the Nismo LSD since like you I couldn't find a better alternative that was available to someone in the US. I'm waiting to see what my friend finds when he dives into the swap but yeah it's amazing how many sizes of shim Nissan lists for the LSD lol.

  • 4 months later...

FYI. Now that my car is on the road and I have about 1000 miles on it, I'll comment on the Nismo Diff.

I LOVE IT!

Super quiet, after about 500 miles of street driving any noticeable chatter has gone away. There is a slight drag when pulling into driveways or at low speeds and extreme steering angles, but that thing grabs like a cat on carpet on throttle. You'd better have the wheel pointed where you want the car to go on throttle because it almost pulls the car in the direction when it hooks. Incredible unit for the money.

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hey all  im wondering if you can help me please I have put a rb20 box in my r34 gtt as my auto packed up and a friend had a spare box I know it’s not ideal but it will get me up and running for now. we have done the conversation and everything is working great but my Speedo we got a s13 speed sensor but my Speedo reads double now and I bought a speed converter but still not having any luck.  so I thought I’ll reach out and pick your brains  any help would be appreciated please as I wanna drive my car again 
    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
    • Nice car! I’m glad folks in the US have gotten past the FnF and are buying real cool cars like the 260RS I was with a bunch of mates in Portland about a year ago and spotted a green Stagea (just a regular 2.5T AWD) parked about 2 blocks away and they were like “a what?” So I made a bet with them for a round of beers and said “ok one of you run down there and tell me if the steering wheel is on the correct side” 5 mins later the American comes trudging back up the hill and goes “he’s right guys. Ok what beer do you want?”
    • Should replace OR drop the tank, give it's good clean. Might be worth replacing that entire fuel level/pump/cradle thing with this: https://frenchysperformancegarage.com/products/fpg-s13-180sx-r32gtst-single-pump-hanger-kit-billet-hat-6-v3-fpg-089?gQT=2  
×
×
  • Create New...