Jump to content
SAU Community

Recommended Posts

Hi Guys,

We are cleaning out a shed full of RB Parts.

RB26 blocks $400.00 Each from standard bore to oversize. 3-5 to choose from

RB30 Blocks A8 Turbo $400.00 Each from standard bore to oversize. 3-4 to choose from

RB26 Cranks - Longnose $400 short nose $175

Arias RB26 Standard bore (86mm) Forged Pistons (set) good condition $300.00 ony need rings.

CP Pistons For a RB30 Block and RB26 Head (set). To Suit 86.5 oversize bore. with rings and pins $500.00

Spool RB30 Rods good condition (set) $500.00

Mahle for a RB30 Block and RB26 Head. To Suit 86.5 oversize bore. 5 out of 6 are band new 1 got damaged on the machine cutting clearances for the oversize valves. $400.00 - it will cost $200 for 1 new piston the set is worth $1200.00 new.

HKS Pistons for a RB26 87mm with rings and pins (set) $400.00

ARP RB25 Head Stud Set - $150

Greddy RB fuel rail $50.00

New Sets of Bearings

heaps of other stuff

twin turbo dump pipes HKS and Stock 34 GTR Dump Pipes

I can freight Australia wide. location Newcastle NSW

contact Adam - 0449 664 330

IMG_3299.jpg

IMG_3280.jpg

IMG_3282.jpg

IMG_3284.jpg

IMG_3285.jpg

IMG_3286.jpg

IMG_3301.jpg

IMG_3290.jpg

IMG_3294.jpg

IMG_3296.jpg

IMG_3297.jpg

  • 5 weeks later...
  • 3 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
    • So 10/10 times that code is coil packs? I mean if that's the case ill drop the $400USD or so to replace them. I didn't know these cars threw codes before the issue became an issue.
×
×
  • Create New...