Jump to content
SAU Community

Recommended Posts

Alright so about 2 days ago ive changed the coolant and actually put coolant into the car as before it just had water running through it, my car has been overheating roughly about 15-20 mins after driving depending on how i drive it if i thrash it it starts climbing but if i drive normally it keeps cool then slowly starts to heat up. Ive started turning the heater on full blast as that sorta fixes the overheating problem while im driving but does this mean it could be the thermostat thats screwed or could it be something more like a blown gasket or something? ive noticed that some hoses on top of the engine have some crystalised brown stuff leaking from them, could thise be the old coolant thats clogged up and crustified there blocking the flow of oolant into the engine? 

also another question are any other struts from other nissan skylines interchangeable with the struts i have now? 

Please any help is appreciated and needed!!! 

Thanks :)

Link to comment
https://www.sau.com.au/forums/topic/465870-problems-with-my-r34/
Share on other sites

Have i bled it? like Burped it?-.......No i forgot too, hopefully that fixes it.

Fluid level is good as the reservoir tank and radiator are always full and only require little bits of coolant to be added after running and turning off but i might need to burp it.

The bottom hose is hot 

and the top hose is firm when its up to temp.

Ive been reading and im thinking it could actually be a blown head gasket.

One day i overheated and my reservoir tank was boiling/bubbling/popping it was going nuts could that be head gasket?

If you haven't been using "anti-freeze" your system could  be full of rust and cr*p.

First try bleeding all the air out (search if you're not sure how).

Get a radiator shop (or your friendly mechanic) to put a pressure tester on the radiator to spot leaks or may tell you if there is a major leak from the head gasket. Have a look through the filler at your radiator core. May need cleaning or replacing.

Get a new radiator cap, sometimes they get old and the spring wont function thus not letting water into the engine at operating temp.
Also do a proper bleed, top up the reservoir past the full line. Top up the coolant, turn the heater on full and whilst the car is running loosen the coolant bleed screw near the front of the plenum until coolant comes out.
Just my 2c on what i would doc40737aa1b7a43fdb50d0c6ccd16e3d0.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Have a vb in honour of the car comming back
    • It was a great, but typical track day, and some VB was ingested at the night time debrief 🤪
    • And so, to round this out, I couldn't be happier to confirm @MBS206 has decided to buy the car. He drove down from sunny QLD with a trailer last week and it is off to its new home today. I'll let Matt confirm on next steps but I understand broadly that the plan is to leave it pretty much as is, and just get some quality wheel time with a nicely balanced car that is pretty much track ready. There are a few a jobs still to be done first but nothing too major and I think its a very smart buy Dinner last night at the Paragon with a round of VBs (mostly) for Neil
    • Well, 50 pages and the end of a chapter for this car. We took it out for a shakedown at Wakie yesterday, and everything went well. There were a couple of niggles: - Oil cooler fitting leak - tightened, cleaned, stopped leaking - Radiator cap overflow fitting was leaking....Mark called it, the overflow fitting was threaded in and not tight....tightened, tested and held pressure - Small oil leak at the rear of the block, probably the turbo oil feed - too hot to get at it comfortably but probably just needs to be nipped up - leak at the driver's side rear brake line where it meets the hardline. Fitting wasn't loose, so Matt backed it off and back on, no further leaks - there's also a leak somewhere on the top of the fuel tank, maybe that cross over fuel line - that was has been left to fix when its on a hoist Otherwise than those niggles the car went great, turned great and stopped great so it was a very successful day out. I'm always really nervous when a car first hits the track after a long break, especially with a brand new engine as well but it was great. VID-20251011-WA0007.mp4  Big thanks to @The Bogan who dropped by and helped out, @MBS206 and my nephew Lachlan the apprentice.  Neil's wife Mel also surprised the hell out of all of us by dropping by; she's up in Tamworth these days but was travelling to Melbourne so had plausible deniability for turning up at the garage, it was great to see her but also obviously a bit sad all round.
    • Skyline R33 Series 2 sedan tail lights in excellent condition. These are becoming harder to find, especially in this state.    BOTH SETS ARE IN FANTASTIC CONDITION (REFER TO PHOTOS)    ✅ No broken covers or cracks ✅ Lenses are in flawless condition ✅ All rear mounting lugs intact ✅ Comes complete as pictured ✅ Perfect for restoration, replacement, or upgrade   These lights are ready to go, no surprises just quality OEM parts.   These are definitely one of the better sets we have seen in a while. With minimal wear and tear they will come as you see. Bear in mind they are not brand new they are almost 30 years old now. To find them in this condition isn’t easy they can only be obtained on the second hand market.   Australia Wide Postage Available At Buyers Expense. Silver Set:$850 Grey Set:$850 PM Me for purchase or any other questions  IMG_2166.dng IMG_2165.dng IMG_2172.dng IMG_2173.dng IMG_2174.dng IMG_2179.dng IMG_2180.dng IMG_2260.dng IMG_2258.dng IMG_2259.dng IMG_2261.dng IMG_2266.dng IMG_2273.dng IMG_2274.dng IMG_2276.dng
×
×
  • Create New...