Jump to content
SAU Community

Recommended Posts

Hey Guys, 

incredibly new to owning a turbo/import as well as not very knowledgeable at all mechanically.

Picked up a R33 GTST a week ago. 

Driving last night I excellerated (not flat but still a bit) and there was a loud pop followed by the engine shutting off. 

I didn’t notice any smoke etc. left the car to sit for a few minutes and started it. 

Ran rough for the first start then quickly went back to a standard idle and ran well at low RPM. 

Nersed it home without hitting 0.00 bar. But if you try to excellerate more the it will not go at all over 0.00. 

Thinking it could have been a pipe that’s blown off, but a quick look at all the intercooler pipes look tight and okay. In saying this I haven’t taken off any covers etc of anything else. 

Engine wise car has few small modifications such as larger front mount, turbosmart E-boost street controller, different BOV, 3” Dump pipe and full exhaust, 200kw dyno time and has been really well taken care off service wise.

is it likely I have blown the stock turbo? Any advice would be greatly appreciated. 

Thanks. 

 

 

 

Edited by Mbarker123
Link to comment
https://www.sau.com.au/forums/topic/474128-r33-gtst-turbo-issue/
Share on other sites

1 hour ago, GeeDog said:

It's an accelerator, and you use it to accelerate. I think excellerator / excellerated has something to do with spreadsheets, or with being excellent.

 

 

Thanks champ! apologies for not proof reading my post. 

I’ll be sure to send you my assignments for a quick proof read before I put them in. 

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I am well aware as I did rant at him to buy a MX5, buy the 2.5 before he DIY'ed it, etc as well as do things to the holden. He will obtain a ND. It's the best of both worlds. They look great in person, definitely the best looking one. Just a matter of time now.
    • Remember this is the same person who said he’d never own an nc 
    • ouch! how is the car now?I had sold my gtr but have been looking into some on trademe and a 260RS but I wouldnt be keen on any repairs needed on them
    • This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
×
×
  • Create New...