Jump to content
SAU Community

Recommended Posts

  • 2 weeks later...

 

On 3/19/2019 at 12:59 PM, Ben C34 said:

 It would be pretty special to get the oil and coolant lines wrong on a turbo but did you?

I don't know. My powers aren't that good.

???

On 3/19/2019 at 12:55 PM, Number1mechanic said:

Hey guys so I've just done my first engine swap and I have oil in my radiator, I have a top mount turbo that's oil and water cooled  so did I get the lines the wrong way around? 

just to be sure that new engine is ok you need to sniff an exhaust if it smells like coolant - congrats, head gasket is blown

Link to comment
https://www.sau.com.au/forums/topic/476375-oil-in-radiator/#findComment-7902078
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...