Jump to content
SAU Community

Recommended Posts

G’morning my skyline R33 turbo,manual won’t start when cold. It will fire eventually but won’t continue to run.Starts first time when hot.I have changed spark plugs & coils. Any information would be greatly appreciated.Thanks Robbert.

Link to comment
https://www.sau.com.au/forums/topic/480108-skyline-cold-start-problems/
Share on other sites

Do you have a strong battery with good connections? Another possibility is the temp sensor for the ecu. It is the one with two terminals ..the one with a single terminal is for your dash gauge. Unplug the ecu terminal and if the car starts better then that one needs to be replaced.

8 hours ago, KiwiRS4T said:

Do you have a strong battery with good connections? Another possibility is the temp sensor for the ecu. It is the one with two terminals ..the one with a single terminal is for your dash gauge. Unplug the ecu terminal and if the car starts better then that one needs to be replaced.

 

47 minutes ago, Nortyone said:

Yes brand new battery and terminals clean as a whistle. Could you please give me more info where ECU is .thx.

 

47 minutes ago, Nortyone said:

Yes brand new battery and terminals clean as a whistle. Could you please give me more info where ECU is .thx.

ECU is in the LHS kick panel but you don't need to access it - disconnect the sensor at the sensor: follow the top hose to the block and you will find two sensors - just pull the plug off the one with two wires.

  • 4 weeks later...
20 hours ago, GDZ32 said:

Is the car on E85? common problem with E85 cars. Just keep cranking lol

Common with a lazy tuner :)

Mine starts in any temperature 1st go, and idles fine.. just doesn't drive very well for the 1st minute haha

25 minutes ago, Dose Pipe Sutututu said:

Mine starts in any temperature 1st go, and idles fine

Out of interest, how often do you start / drive it? Does it sit for weeks/months, then still start first go?

Have an R33 GTST track car with lots of mods, including E85. It starts fine when cold if it's run regularly, but if it sits for a while (> a month) it's very hard to start - crank until battery goes flat, recharge & try again....

31 minutes ago, GeeDog said:

Out of interest, how often do you start / drive it? Does it sit for weeks/months, then still start first go?

Have an R33 GTST track car with lots of mods, including E85. It starts fine when cold if it's run regularly, but if it sits for a while (> a month) it's very hard to start - crank until battery goes flat, recharge & try again....

Probably once every 2 weeks and yes it just sits around in my back yard. Last time I drove it was at the Sparesbox skid pan (performed terribly, never take a track car to a skid pan, it doesn't skid very well)

E85 is fun, there's a fine line between wetting the plugs and not starting and not enough cranking fuel to get it started. Then there's all the other dimensions of intake air temp, ethanol concentration, etc. I find adding a good amount to the initial prime table makes all the difference. Happy to send you my kebabtech tune file for R&D if you like.

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hope you aren't too sore after that one, might take a day or 2 to notice yet and I guess it is a loooooong drive home. On the bright side, tube frame front end is a thing at superlap, right?
    • https://www.facebook.com/share/p/18rmVb1SKB/ 
    • The chart of front pressure to rear pressure (with one being on the x axis and the other being on the y axis) is not a straight line on a typical proportioning valve. At lower pressures there is a straight line with one slope, and at higher pressures that changes to a lower slope. That creates a bend in the line at that pressure, called the knee point. If you do not change the proportionng as the pressure gets higher, you will suffer excessive pressure (at one end of the car or the other, depending on which way you look at the proportioning action) and then get lockups at that end. The HFM BM57, from my memory of previous discussions, is based on the BM57 from a different car (to a Skyline), with a different requirement for the location of the knee point and the distribution of pressure front to rear, and so is not a good choice for an upgrade on a Skyline. Here's a couple of links to some old posts, one from here, one from elsewhere. A lot of it pertains to adjustable prop valves, but the idea is the same. There are plenty of discussions on here about this issue from al the many years of people wanting a cheap/accessible option. https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/ https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/  
    • Yeah dunno why johhny posted that here with no context, just post on FB/insta bro where he put it up?  Laine had an off at T4 during Thurs prac, he's ok, car is less than perfect, they are done for the weekend, he can fill in the rest. Bando also binned it like 100m up the road.   
    • I feel there must have been a FB/insta post and the weekend did not start well at all I hope everyone is all okay
×
×
  • Create New...