ocean Posted December 23, 2004 Share Posted December 23, 2004 Hey guys, Some of you are already familiar with the R32 GT-R I recently purchased through Prestige Motorsport. The car is now in the garage undergoing a fair bit of work! There are pictures of my progess in the gallery. Can anyone identify what intercooler that is? As far as i can tell the worst of the damage is to the front RH rail (pic in gallery) which has a slight ripple in it, and looks to have been pushed back by about 10-20mm or so. The centre of the radiator support (at the bottom) is back by around 20-30mm. This should be quite repairable by heating the rail and slowly pulling it back out into shape. I don't think a new support panel is required (thank god, i hate doing radiator support work) The story given to me by the supplier (accident happened on a dirt road) is consistent with the damage, as it looks to be a wide frontal impact, rather than a point impact. The amount of japanese dirt in there is unbelievable. The back seat is loose, and there are no seat belts in the back whatsoever.. I do not know how this car passed quarantine. Let me know what you think, -Patrick == UPDATE == The list of things to do: Todo: Engine flush Radiator flush B Engine Oil B Engine Oil Filter B Gearbox oil B Transfer Case Oil B Front Diff Oil B Rear Diff Oil B Coolant B Fuel Filter B Brake Fluid Power Steering Fluid Air Filters Windscreen Wipers Tyres Alarm Rear Discs Injector Service Timing Belt Valve Lash Inspection (maybe..) Done: Compression Test - 1: 120 2: 120 3: 105 4: 115 5: 115 6: 105 Spark Plugs - Used NGK BCPR7ES - Left at standard 1mm gap, will re-gap depending on tune Brake Pads - First inspection look ok - Check rear pads for uneven wear - Rear discs need replacement due to excessive wear Turbo Inspection - Some oil in intercooler piping (both in and out of compressor housing) - Shaft play does not seem excessive, bearings appear to run smoothly - Does anyone know how to check the turbos properly? For anyone who is interested, here are the costs involved in this. If anyone is interested i will keep this up to date as i go along - note that there are a few estimates involved - I have tried to err on the expensive, rather than the cheap side (no doubt i have also left a couple of things out). Raw Vehicle BNR32-003446 $10 759.61 Shipping $ 4 686.34 Prestige Motorsport $ 1 100.00 $16 545.95 On Road Costs Compliance $ 1 000.00 RWC $ 500.00 Registration $ 500.00 Stamp Duty $ 500.00 Insurance $ - $ 2 500.00 Frontal Damage Front Bar Cover $ 300.00 Lower Lip Spoiler $ (est) Headlights (pair) $ (est) Intercooler $ (est) Air con condenser $ (est) Radiator $ (est) Bar Support $ (est) Lower Radiator Support $ (est) Panel Beating + Paint $ 1 500.00 (est) $ 4 000.00 Maintenance Z145A Oil Filter $ 10.99 Z387 Fuel Filter $ 35.99 Motul 8100 Oil $ 61.99 Nulon G70 G/Box Treatment $ 23.99 Motul 300 Gear Oil (x 2) $ 53.98 Motul RBF600 Brake (x 2) $ 61.90 Motul Dexron III $ 15.99 4PK925 Fan Belt $ 23.99 4PK950 Fan Belt $ 27.99 4PK875 Fan Belt $ 20.99 Battery $ 89.99 Timing Belt $ 50.00 (est) $ 477.79 Cleaning Wheel Cleaner (x 3) $ 44.97 Carpet & Interior Cleaner $ 14.99 303 Interior Protectant $ 14.99 Interior Steam Clean $ 200.00 (est) $ 274.95 Other Costs Lock Nuts $ 24.99 Stud for rear turbo $ - Broken Spanner $ - Bolts for coil support $ 5.00 Rear discs $ 600.00 (est) $ 629.99 Total ORC $24 528.68 Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/ Share on other sites More sharing options...
someonestolecc Posted December 23, 2004 Share Posted December 23, 2004 Congrats P. seemed like 'twas only yesterday you said "I bought this car". I'm glad it's on your lawn and it wasn't too much trouble with the quarantine (it might be possible it got fumed). Good luck fixing it etc - keep us updated on your project. I hope all goes well. Merry xmas to you too. Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135098 Share on other sites More sharing options...
ocean Posted December 23, 2004 Author Share Posted December 23, 2004 The gallery is being a shit, it hangs up on one photo when it tries to create the thumbnail, and it won't let me delete that photo either!! GRR!! -Patrick Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135109 Share on other sites More sharing options...
Sarumatix Posted December 23, 2004 Share Posted December 23, 2004 wow congrats.. i'm waiting on my 'line atm . Good to hear Geoff has delivered for you, I hope my fortunes are the same . Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135112 Share on other sites More sharing options...
Beer Baron Posted December 23, 2004 Share Posted December 23, 2004 yeah, I was just going to say that I can't see any pics in your profile. Congrats on getting the car mate. Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135116 Share on other sites More sharing options...
skylinedrifter Posted December 24, 2004 Share Posted December 24, 2004 hehe, ive seen your car on PM, nice car btw. if i remember accurately, the car also blows white smoke eh ? Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135183 Share on other sites More sharing options...
ocean Posted December 24, 2004 Author Share Posted December 24, 2004 i was told blowing black smoke, probably due to hole in intercooler - considering the hole in the cooler is massive i'm not surprised - this will cause a whacked AFM signal.. Can anyone tell me how to fix this gallery problem, i have another 20 pics i would love to add, especially some close ups of the chassis rail and radiator support -Patrick Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135193 Share on other sites More sharing options...
colinhunt Posted December 24, 2004 Share Posted December 24, 2004 congrats on getting your car dude .... sorry to hear that it has arrived perhaps not as you hoped ... shouldn't take too much to fix it though hopefully merry christmas ! Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135202 Share on other sites More sharing options...
ocean Posted December 24, 2004 Author Share Posted December 24, 2004 I knew it was damaged.. I guess it hasn't really surprised me yet, I'm hoping that the engine/transmission/clutch are all in good order.. Has anyone heard of a computer that says "GRID" on it? =Patrick Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135246 Share on other sites More sharing options...
ocean Posted December 24, 2004 Author Share Posted December 24, 2004 A fair few of the pics have worked now.. The gallery is starting to give me the irits.. -Patrick Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135323 Share on other sites More sharing options...
Driver Posted December 24, 2004 Share Posted December 24, 2004 so ull be able to get it road registerd oK? Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135407 Share on other sites More sharing options...
Autech Posted December 24, 2004 Share Posted December 24, 2004 That's excellent news mate! Congratulations, that's a very nice Christmas present! I'm sure it won't take much to fix, give it a really good going over and you'll be cruising your very own GT-R down the highway before you know it!!! Steve Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135436 Share on other sites More sharing options...
pentae Posted December 24, 2004 Share Posted December 24, 2004 Would love to be able to see those pics.. if you email them to me webmaster AT easyautobits.com i'll host them for you or post them up if your having problems.. Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135693 Share on other sites More sharing options...
ocean Posted December 24, 2004 Author Share Posted December 24, 2004 Would love to be able to see those pics.. if you email them to me webmaster AT easyautobits.com i'll host them for you or post them up if your having problems.. It should be road registerable without any trouble. I'll send you those pics, someonestolecc was going to try to host them but something seems to be going wrong with his email.. Thanks, -Patrick Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135895 Share on other sites More sharing options...
ocean Posted December 24, 2004 Author Share Posted December 24, 2004 I think i managed to get all of the photos working in the gallery now.. some of them have been duplicated though. I actually got it running yesterday - taped up holes in intercooler and started it. Ran like a bucket of shit (as i expected) there are probably still lots of leaks in the air flow path, looked like it was running rich as buggery, and sounded like only 3 or 4 cylinders.. Going to do a compression test soon.. -Patrick Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135901 Share on other sites More sharing options...
NismoGirl Posted December 24, 2004 Share Posted December 24, 2004 Can anyone identify what intercooler that is?-Patrick AFAIK... it looks like the HKS end tanks? So maybe HKS? Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135904 Share on other sites More sharing options...
ocean Posted December 24, 2004 Author Share Posted December 24, 2004 AFAIK... it looks like the HKS end tanks? So maybe HKS? Also looks suspiciously like a R34 GT-R Intercooler, here is a pic: http://www.upimports.com.au/UPI_Parts/Pics...ercooler_02.jpg The mounts and top bracket all look identical. -Patrick Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135907 Share on other sites More sharing options...
ylwgtr2 Posted December 24, 2004 Share Posted December 24, 2004 looks like an easy fixer.....but your changing the lower rad support right?They are quite cheap to buy new....it might end up a better job if you changed it...... Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135913 Share on other sites More sharing options...
ylwgtr2 Posted December 24, 2004 Share Posted December 24, 2004 has the rail gone back into the bulkhead at all or is it just the tips of the rail?Would be nice to get it up on a bench just to check the underbody measurements eitheir way...or are you just gunna pull it on a flat rack? Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135915 Share on other sites More sharing options...
ocean Posted December 24, 2004 Author Share Posted December 24, 2004 ylwgtr2: I have put one more photo in my gallery that is a low front on shot. The front subframe is untouched. I'm sure the lower support could be fixed, but if one is easily available it will be replaced. I would like to check the underbody measurements properly, it's no use fixing it by half. As far as pulling it, we haven't decided exactly how to do that yet, either on a rack or with a porta-power or something similar. Do you know of a good source for a lower radiator support? -Patrick Link to comment https://www.sau.com.au/forums/topic/59504-car-has-arrived-merry-christmas/#findComment-1135926 Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now