Jump to content
SAU Community

Recommended Posts

ive never driven a R33 but it does seem it has more torque at the start than a R32. however once the R32 hits 3revs and over it lets u know its a skyline!!! :D

same would apply for a R33... but in a straight line launch you wouldn't start from below 3,000rpm

R33's are faster.. have more room, and are more modern.

R32's are more compact, feel more sporty, and have more direct and better handling

I've owned both, and the R32 already feels much better. With an RB25 engine, it would clearly be the fastest and better handling car.

I have both an R33 & R32 sedan with FMIC,3" from turbo, T/s plumbback, on both, the 33 is quicker and feels alot more refined but for those sideways adventures and tight corners the 32 feels much more responsive.

The 33 is now running lowered spings and both have camber & caster adj. bushes set up for sport and the 33 only just comes close to the feel of the 32.

Never raced them together(can't drive 2 cars at once)so I'm going by speed and feel on same stretch of road.

stock the 33 won hands down for being quicker.

R33's are faster.. have more room, and are more modern.  

R32's are more compact, feel more sporty, and have more direct and better handling

I've owned both, and the R32 already feels much better. With an RB25 engine, it would clearly be the fastest and better handling car.

Yeah i totally agree, the R32 makes up for its sportyness feel. Here in the NT we have no speed limits on the main highway and i pushed my R32 all the way and its got superb handling, all 4's stick to the road.

  • 2 weeks later...

My experience in the past

My R32 used to run 12.5psi and made ~150rwkw with only an exhaust.

A friend with an R33 was running 11psi with a pod and exhaust.

The R32 used to pull away from the R33. Not by much but it was slightly quicker.

My R32 also used to sit dead smack even with another friends dead stock R33 GTR (Stock exhaust and all)

BUT... Once you begin to fiddle with the ecu on the R33's they leave the R32's for dead.

Dead stock R32 vs dead stock R33, the R33 is quicker.

Very mild exhaust and boost R32 vs very mild exhaust and boost R33, the R32 is quicker.

I put this down to the ECU in the R32 handling the mods a little better than the R33 as the R33's tend to have slight power dips and run very much rich!

R33's are faster.. have more room, and are more modern.  

R32's are more compact, feel more sporty, and have more direct and better handling

I've owned both, and the R32 already feels much better. With an RB25 engine, it would clearly be the fastest and better handling car.

Your R33 was manual, and your R32 is auto.. You can't compare them really Gordo.

My R32 vs unknown R33 I found on a *private straight part of road* I won by a half car length. I only made 140rwkw as well.

I’ll admit once you start and play with the R33 more, it’s a quicker car, but with the normal basic bolt on’s – The R32 is quicker IMHO.

ive got a r32 gtst and my bro has a s2 r33 gtst

overall id easily rather do up an r33 ... its just soo much nicer on the inside plus dual airbags... havent driven a stock r32 for handling but mines on teins and it handles like a gun the steering on my brothers feels a bit airy but i think we aftermarket suspension it would handle fine

we are both putting out about 190rwkw and when we raced he beat me on the start got a lot of wheelspin but after shifting to 2nd the r32 took off ahead but mines pretty heavily modded

but if your cashed up go a late model r33

Your R33 was manual, and your R32 is auto.. You can't compare them really Gordo.

My R32 vs unknown R33 I found on a *private straight part of road* I won by a half car length. I only made 140rwkw as well.

I was mainly getting at how they are to drive, the handling, the "feel" of driving and sitting in one, not necessairly the straight line performance. Through the mountains the other night, the R32 was much better totally stock, and crappy auto as well.. than the handling of my old R33 ever was.

anyhow, the r32 will be manual soon enough..

I'm going to stick the RB25 turbo on the r32 in a month or so.. that will be interesting.. as the stock 32 turbo is a bit too undersized for the engine.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Power is fed to the ECU when the ignition switch is switched to IGN, at terminal 58. That same wire also connects to the ECCS relay to provide both the coil power and the contact side. When the ECU sees power at 58 it switches 16 to earth, which pulls the ECCS relay on, which feeds main power into the ECU and also to a bunch of other things. None of this is directly involved in the fuel pump - it just has to happen first. The ECU will pull terminal 18 to earth when it wants the fuel pump to run. This allows the fuel pump relay to pull in, which switches power on into the rest of the fuel pump control equipment. The fuel pump control regulator is controlled from terminal 104 on the ECU and is switched high or low depending on whether the ECU thinks the pump needs to run high or low. (I don't know which way around that is, and it really doesn't matter right now). The fuel pump control reg is really just a resistor that controls how the power through the pump goes to earth. Either straight to earth, or via the resistor. This part doesn't matter much to us today. The power to the fuel pump relay comes from one of the switched wires from the IGN switch and fusebox that is not shown off to the left of this page. That power runs the fuel pump relay coil and a number of other engine peripherals. Those peripherals don't really matter. All that matters is that there should be power available at the relay when the key is in the right position. At least - I think it's switched. If it's not switched, then power will be there all the time. Either way, if you don't have power there when you need it (ie, key on) then it won't work. The input-output switching side of the relay gains its power from a line similar (but not the same as) the one that feeds the ECU. SO I presume that is switched. Again, if there is not power there when you need it, then you have to look upstream. And... the upshot of all that? There is no "ground" at the fuel pump relay. Where you say: and say that pin 1 Black/Pink is ground, that is not true. The ECU trigger is AF73, is black/pink, and is the "ground". When the ECU says it is. The Blue/White wire is the "constant" 12V to power the relay's coil. And when I say "constant", I mean it may well only be on when the key is on. As I said above. So, when the ECU says not to be running the pump (which is any time after about 3s of switching on, with no crank signal or engine speed yet), then you should see 12V at both 1 and 2. Because the 12V will be all the way up to the ECU terminal 18, waiting to be switched to ground. When the ECU switches the fuel pump on, then AF73 should go to ~0V, having been switched to ground and the voltage drop now occurring over the relay coil. 3 & 5 are easy. 5 is the other "constant" 12V, that may or may not be constant but will very much want to be there when the key is on. Same as above. 3 goes to the pump. There should never be 12V visible at 3 unless the relay is pulled in. As to where the immobiliser might have been spliced into all this.... It will either have to be on wire AF70 or AF71, whichever is most accessible near the alarm. Given that all those wires run from the engine bay fusebox or the ECU, via the driver's area to the rear of the car, it could really be either. AF70 will be the same colour from the appropriate fuse all the way to the pump. If it has been cut and is dangling, you should be able to see that  in that area somewhere. Same with AF71.   You really should be able to force the pump to run. Just jump 12V onto AF72 and it should go. That will prove that the pump itself is willing to go along with you when you sort out the upstream. You really should be able to force the fuel pump relay on. Just short AF73 to earth when the key is on. If the pump runs, then the relay is fine, and all the power up to both inputs on the relay is fine. If it doesn't run (and given that you checked the relay itself actually works) then one or both of AF70 and AF71 are not bringing power to the game.
    • @PranK can you elaborate further on the Colorlock Dye? The website has a lot of options. I'm sure you've done all the research. I have old genuine leather seats that I have bought various refurbing creams and such, but never a dye. Any info on how long it lasts? Does it wash out? Is it a hassle? What product do I actually need? Am I just buying this kit and following the steps the page advises or something else? https://www.colourlockaustralia.com.au/colourlock-leather-repair-kit-dye.html
    • These going to fit over the big brakes? I'd be reeeeeeeeaaaall hesitant to believe so.
    • The leather work properly stunned me. Again, I am thankful that the leather was in such good condition. I'm not sure what the indent is at the top of the passenger seat. Like somebody was sitting in it with a golf ball between their shoulders. The wheels are more grey than silver now and missing a lot of gloss.  Here's one with nice silver wheels.
    • It's amazing how well the works on the leather seats. Looks mint. Looking forward to see how you go with the wheels. They do suit the car! Gutter rash is easy to fix, but I'm curious about getting the colour done.
×
×
  • Create New...