Jump to content
SAU Community

Recommended Posts

check out the rb25 turbo upgrade dyno post (search for it) and find the most laggy looking dyno graph. copy their mods and you shold be sweet. i suspect the hks2540 will be the most laggy or gt30 with stock internals, the gt30 is suited for a midly tweaked engine

what makes u think i want lag i said all along i want 250 with torque, grunt ,response not LAG :D

  • Replies 40
  • Created
  • Last Reply

Top Posters In This Topic

quote:

"i figure i should run the more boost like 1.1bar to make it rather than go external wich requires less psi but more lag. MY REASON: so on std boost my wife wont shit herself when it come on!!!"

that says to me i want high power top end (fine) but i want lag so my wife doesnt get angry when 200rwkw spits out at 2000rpm, so therefore i want a laggy setup.

am i wrong? if so thats ok, ill chage my previous posts

but from the info you gave (limited) it said to us you want a laggy turbo thar had good top end. laggy so your wife didnt have a fit, and good top end so you could enjoy it when u kept the throttle nailed down

dude,

the HKS GT2835R is your best solution, it will give you the air-flow you need for 250rwkw with the response you require as a street car.

Garrett also offer the same spec turbo with an internal wastegate which flows the same a the HKS turbo, so financially this would be the cheaper way out.

I think you need an automatic SS commodore..... 5.7l v8.....'

Perfect soccor mum car with a bit of go.... LOL

Nah just kiding, back to the topic. HKS 2535 will see the figure you want with the responce you admire. Sard or malpassi rising rate FPR and your set.... Around 18psi i reckon and 250rwkw is possible. Assuming you have an exhaust and FMIC....

its rb25t my mistake,

but just so u know high compresion na motors arent a  

bad thing with turbos u get a lot more grunt down low u  

spin any turbo round 1200rpm faster u just need to tune  

ur ecu properly did it twice on a vl and a skyline and i ran  

26psi threw the skyline wich i didnt need wiv t3/4 combo  

and 2000rpm gave full boost an massive burnout torque.  

tru story  :D

thats the most rubbish filled post i've read this week.

1200rpm sooner on an N/A motor... which one?

RB30 (vl) has a lower compression to start off with in the N/A so a turbo conversion is nicer...

anyhow. Your after an RS500 said... a HKS 28XX... or basically a Garrett GT28, around the 450HP mark will get you what you want.

thats the most rubbish filled post i've read this week.

1200rpm sooner on an N/A motor... which one?  

RB30 (vl) has a lower compression to start off with in the N/A so a turbo conversion is nicer...  

anyhow. Your after an RS500 said... a HKS 28XX... or basically a Garrett GT28, around the 450HP mark will get you what you want.

that was my na skyline silouette wiv factry LSD 4 skidz

RUBBISH is not what my mates said as i painted his street black with mountains of torque

dont be fololed by thinking high comp is bad!!

Forget that i ran 26psi it was becuase the t3/4 internal gate was faulty and

wouldnt open so i ran what it pumped and that was 26psi.

it made ruffly the same power/ torque with 1 bar as opposed to a low comp motor

with needs much higher boost to compensate like 20 and more.

try it then say its rubbish until then SHUT YOUR MOUTH

that was my na skyline silouette wiv factry LSD 4 skidz  

RUBBISH is not what my mates said as i painted his street black with mountains of torque

dont be fololed by thinking high comp is bad!!

Forget that i ran 26psi it was becuase the t3/4 internal gate was faulty and  

wouldnt open so i ran what it pumped and that was 26psi.

it made ruffly the same power/ torque with 1 bar as opposed to a low comp motor

with needs much higher boost to compensate like 20 and more.

try it then say its rubbish until then SHUT YOUR MOUTH

:D

You think with Fuel pressure regulator and a good fuel pump the stock fuel system would be able to support 250rwKw? (and I'm from perth ehhehe :headspin: )

Im about to try a 2535 but dont have injectors at the moment, hope it'll get 250kw

will have results by end of month

Stock injectors will be fine for 250rwkw, like i said, got 2 mates with gtst's who both run 2535's, make about 250rwkw, very responsive... both on stock injectors...

HeathGTST owns 'MSPEC2'... DentonR33's old car... is one

the other one is on the forums as MSPEC i think....

I don't know about the GTRS or other turbos... i just know what my friends used... and thier cars are very quick.... they both run PowerFC's tuned by RacePace.

Stock injectors will be fine for 250rwkw, like i said, got 2 mates with gtst's who both run 2535's, make about 250rwkw, very responsive... both on stock injectors...  

HeathGTST owns 'MSPEC2'... DentonR33's old car... is one

the other one is on the forums as MSPEC i think....

I don't know about the GTRS or other turbos... i just know what my friends used... and thier cars are very quick.... they both run PowerFC's tuned by RacePace.

2535 sounds like the ONE

what they worth ?

does nengun sellem?

I high flowed a standard r33 comp. Had steel wheels fitted an the BB cartridge replaced. They also changed my exhaust wheel to a different type (unknown origin).

I reached 217rwkw at 10psi on strock injectors and just a piggy back system....

(Had to drop the cat out so the exhaust could flow, as at the time i had a stock exhaust.)

Now im up to around the 250rwkw roughly when i use my race pipe. Then with the stock exhaust re connected it turn it down a little to around 200rwkw.....

I high flowed a standard r33 comp. Had steel wheels fitted an the BB cartridge replaced. They also changed my exhaust wheel to a different type (unknown origin).  

I reached 217rwkw at 10psi on strock injectors and just a piggy back system....

(Had to drop the cat out so the exhaust could flow, as at the time i had a stock exhaust.)

Now im up to around the 250rwkw roughly when i use my race pipe. Then with the stock exhaust re connected it turn it down a little to around 200rwkw.....

thats good power from a hi flow

what boost gave u 250?

i have not cnfirmed 250rwkw with the boost turned up...

I have a list of mods as long as my arm.... 217rwkw was with just boost and a few minor mods, or common mods you may say...

I am only estimating 250rwkw at 16psi.... It would be very close to this figure tho....

Its all about the supporting mods, you could make 250rwkw from a stock setup (for about 1 second) then she would go BOOM. So its about reliable power to me... I run 200rwkw daily, for fuel reasons. Then i can turn it up with 20 minutes work....

Hi Guys, I thought that we had covered all the possible threads on turbos for RB25's, and everyone was using the search button. But then up pops another one, exactly the same

(usual) question.......so I give the same (usual) answer........

We have an R34 GTT that makes 265rwkw (355 rwhp) on a GCG ball bearing hi flow, and it makes more power EVERYWHERE than it did standard. That is pretty close to the 450 bhp that the hi flow is rated at. For a half days work, bolt on (no fabrication required) it is hard to beat. Plus it looks STANDARD, never going to have a rego inspection problem at any level. That was 2 1/2 years ago, what about the new turbos released since? Well, despite having plenty of other choices, I am using a GCG ball bearing hi flow on the Stagea.

My 20 cents worth:cheers:

its rb25t my mistake,

but just so u know high compresion na motors arent a  

bad thing with turbos u get a lot more grunt down low u  

spin any turbo round 1200rpm faster u just need to tune  

ur ecu properly did it twice on a vl and a skyline and i ran  

26psi threw the skyline wich i didnt need wiv t3/4 combo  

and 2000rpm gave full boost an massive burnout torque.  

tru story  :rofl:

On pump fuel? For how long?

Not even a std RB25det would last long on 26psi, if run constantly.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hi GTSBoy, Excuse my ignorance but what does a "Bad" Knee point mean ? 
    • HFM BM57 has a "bad" knee point, IIRC. It's not the same thing as the later R chassis MC.
    • The ATTESSA is functionally identical to R34; there were a bunch of JDM models that continued ATTESSA including Fuga/Q70, Skyline/Q50, Cima etc as an option. All with Auto only and I think mostly for snow regions. AFAIK there were no AWD VR30DDTT sold in Australia - it is on my to do list to check regs for racing a LHD car in Targa/ATR/AASA/CAMS events because if I can get the auto to work it would be interesting to run a 4wd car The Ecuteck TCM tuning is the same model as their ECU tuning, they already have it for R35 and Dose's favourite, BMW. You buy "points" to allow your computer to be tuned, buy either a bluetooth (phone app) or bluetooth+USB+Key (phone and PC) dongle, and pay for a tune that will be locked to your tuner ( ). You can also access the tuning software yourself but 1. it is mega expensive and 2. these computers have a billion parameters that intersect, so how could you ever spend enough time on it to get a decent result.
    • Or, is it a case of what it is like owning an R series Skyline? NFI what the previous owner has done or fiddled with... Ha ha ha After reading through this thread, I went on a bit of a research about the Q50/Q60. Now I'm quite intrigued by them! Is the AWD in them more like a WRX where it's always AWD, or is it more like the ATTESSA in the GTRs? By the sound of this TCU tuning, this sounds like a case of someone has made some real software for it, and you just need the right piece of hardware, and then you license that specific vehicle/TCU. Or is this a case of the software will be really expensive so only a few tuners have it, and you still have to pay a license per vehicle?
    • By popular demand.. it was a coil. Got my hands on 1 new OEM coil, replaced with the one that made the less noise difference when I unplugged it while the car was running and started the car up. No stutter and the engine light was gone. I guess I’ll buy the other 5 they have lol
×
×
  • Create New...