Jump to content
SAU Community

Changed oil to redline

rmahnovetsky

By rmahnovetsky,
in General Maintenance

 Share

Recommended Posts

rmahnovetsky Proficient

rmahnovetsky

Posted
Posted

Well it was time for my r33 to get its gear box and diff oil changed. Looking around on the forum I read redline was a good brand. But when I looked at the price I thought twice. $130 to change my oil!!! #$%#$ But I also read on the container it has 400 000 klm before you have to change it again. mmmm!!

Ok well the fact that I will never have to change the oil again and the container did say racing use :P my arm was twisted..

So into the garage I went, changed the oil, and took here for a drive. I noticed the gear changing were a little smoother but apart from that not much else.

later that night.. I went down the cost and dragged 4 cars. Ok now I noticed the oil come into play. I could flat shift this baby like the gear box was mean't for it. I also notice my schro mesh problems in 2nd was gone!! Never again since has my gear box felt crunchy.

FYI: I used castrol vm 80/90(castol something) previously..

Link to comment
https://www.sau.com.au/forums/topic/69746-changed-oil-to-redline/
Share on other sites
Damo Community Regular

Damo

Posted
Posted

I have some redline gear oil ready to go in too at the moment. How much did you use? I brought 2 US gallons of it (about 7.4 lts) to do the gear box and diff. I have read numerous posts and there seems to be a conflict of gear box oil quantities. I have seen the range from 2.5 lts to 3.5lts.

GR33DY Enthusiast

GR33DY

Posted
Posted

yeah red line is awesome.. i had a problem with my clutch on my S15. everytime i drop gears and slowly release my foot off the clutch, it would vibrate ALOT!! I put redline gear box fluid in and some TEFLON gearbox treatment, and after 400kms never happened aggain and gears feel way smoother too!!

Rob

rmahnovetsky Proficient

rmahnovetsky

Posted
  • Author
Posted

I bought the shock proof 4L 85/90 I think (I let the saleman work it out for me) for the gearbox and the 75/140 1L for the diff. I used all the 1L plus a little of gear box oil. I think the diff took about 1.5L and the gearbox about 2.5L.

lwells Grand Master

lwells

Posted
Posted
I used just over 4l in my gearbox..

LW.

I just double checked, and the R32 GT-R workshop manual says you need 4.1l (for the R32 GT-R gearbox, obviously). Given that the R33 GTS-t gearbox is meant to be quite similar to the R32 GT-R box, I find it suprising that some of you guys have put so little oil in?

LW.

Sambo33 Grand Master

Sambo33

Posted
Posted
Given that the R33 GTS-t gearbox is meant to be quite similar to the R32 GT-R box, I find it suprising that some of you guys have put so little oil in?  

LW.

Thats what i thought too, but the guy who told me that 2.5L was all that was needed was a tranmission specialist. He said as long as the gears are picking up oil the trans will be fine and that too much oil will overheat it.

boj01 Experienced

boj01

Posted
Posted

I also changed my gearbox oil to Redline after my car wasn't engaging 1st gear very well on down change (FJ20 Box). It needed about 2.2L and after about 500km it worked its magic. Gear changes are now smoother and not at notchy and it engages all gears perfect.

I've also heard this works wonders on Toyota boxes as they are known to be notchy and stiff.

siksII Grand Master

siksII

Posted
Posted

it has worked well on my previous r33, i recently put it in my new one, but as benm says it takes around 500kms to make a big difference but so far its already better(only driven maybe 100km)

gbox took about 2.8L, i just fill it till it reaches the hole..

diff took 1.3L, didnt use redline, used castrol, heavier weight.

BOOST ON Collaborator

BOOST ON

Posted
Posted
it has worked well on my previous r33, i recently put it in my new one, but as benm says it takes around 500kms to make a big difference but so far its already better(only driven maybe 100km)  

gbox took about 2.8L, i just fill it till it reaches the hole..

diff took 1.3L, didnt use redline, used castrol, heavier weight.

where can i get some redline oil for my baby???

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      Duncan's V37.......race car?

      By MBS206 · Posted

      Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • RP1421
      S15 Spec R

      By RP1421 · Posted

      As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • joshuaho96
      R32 GTS (RB20DE) Injectors Replacement

      By joshuaho96 · Posted

      I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...