Jump to content
SAU Community

THE (ONLY) DECA results/photos/experiences/reviews/recollections/brags thread


Recommended Posts

I love the one of you Roy where you just clip the cone.  Precision sideways....  or pure arse.

Pure arse as you can tell with the spin 2 seconds later...then again 5 seconds after that. I hate htose ones where you have greater then 90 deg to turn as i cant use the handbrake:(

Where is Geoff...teach me Obey-One :)

  • Replies 199
  • Created
  • Last Reply

Top Posters In This Topic

The clip posted is one of the last ones from that 'khana and I think that was Shiv ... thoough, it's all a bit of a blur now so don't take my word for it.

yep that was me getting chopped by the tree fiddy

I know DavidM (350Z @ DECA) has some footage - not sure of what though.

What I have is what I already posted. I do have more, but it's more of the same ie. no footage of the back-track or the slalom knock-out competition.

ps. Where's the 'gathering' going to held next Tuesday?

Anyone else from WRX or Fangers got some footage from this event.  I still need some good stuff from the back track.

I forgot my Camera, blame the early morning, altho my photography skills are as reliable as my driving so wouldn't help you much there either :rofl:

I'm waiting to see Joel's pics!

miniwog

I'm just upset/depressed/suicidal that no-one has any footage of the TX5 giving Aaron a run for his money.

Send me a PM with your e-mail and I'll e-mail you a clip of the TX5 dodging the cones in one of the morning 'khanas as I did get one of your runs on tape. It's 2.45Mb in size.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...