Jump to content
SAU Community

Recommended Posts

Hey everyone,

I've just found out my R32 GTR has just cleared customs in Brisbane and will be delivered to the Seaway depot in Adelaide in about a week.

My question is: what's the best way to get the car from the depot to your house? Have people just driven them there (with temp permit etc.)?

I'm worried that the car hasn't been driven for a good 6 months and I'll do damage to it with old fluids in there etc. It's also likely the battery's dead.

If I were to change the oil & filter, and jump start it, would that be safe to drive home? Driven very safely of course.

Otherwise I'll just organise a tow and hope they don't kill my front bumper!

Cheers,

Alan :)

Link to comment
https://www.sau.com.au/forums/topic/79321-picking-up-a-freshly-imported-car/
Share on other sites

couple of things if you are hell bent on driving it home.

1. The battery WILL be dead. no doubt about that. so buy or borrow a jumper pack.

2. there will be next to 0.00 litres of fuel in the tank so you will have to buy or borrow a container of fuel to take with you (98 RON of course). try to get at least a 10 litre container

3. check the brake fluid and brakes. it will have absorbed quite a bit of moisutre over that time sitting still and the rotors will be rusted up quite nicely. the car will not be stopping too well straight off the boat.

4. check the oil. dunno if i'd go to the extent of changing it on the spot, but certainly make sure there is some in it, and that it's topped up.

5. also be aware of problems like stolen steering wheel, stolen gear knob (has happend to me and is a bitch with a a/m gearset that requires a firm hand), stolen boost controller (may be running unlimited boost) etc.

if you have your wits about you it shouldn't be a problem, but all those hassles make you think maybe you are better off just getting a tow...

if your worried about it put it on a trailer

how do you plan to change oil and filter prior to moving it anywhere, you can do it at the depot

when i picked mine up i took spare battery, 20L of bp ultimate (to dilute what little fuel that was in there and would have been off from sitting for 6 months), oil ect. i also checked oil levels, coolant levels, brake fluid levels ect prior to driving off.

couple of things if you are hell bent on driving it home.

1. The battery WILL be dead. no doubt about that. so buy or borrow a jumper pack.

2. there will be next to 0.00 litres of fuel in the tank so you will have to buy or borrow a container of fuel to take with you (98 RON of course). try to get at least a 10 litre container

3. check the brake fluid and brakes. it will have absorbed quite a bit of moisutre over that time sitting still and the rotors will be rusted up quite nicely. the car will not be stopping too well straight off the boat.

4. check the oil. dunno if i'd go to the extent of changing it on the spot, but certainly make sure there is some in it, and that it's topped up.

5. also be aware of problems like stolen steering wheel, stolen gear knob (has happend to me and is a bitch with a a/m gearset that requires a firm hand), stolen boost controller (may be running unlimited boost) etc.

if you have your wits about you it shouldn't be a problem, but all those hassles make you think maybe you are better off just getting a tow...

my battery worked fine and the car had been sitting for 6 months prior to shipping, so it wont DEFINATLY be dead, cos mine wasnt, but your right its very very likely. and your also right about the brakes, they were ****ing awfull on the drive home, still safe enough taking it slowly, but shithouse all the same

I had a quick look of fluids ect- jump started it and put in 10 litres of bp ultimate- brakes locked up for the first few stops but ran sweet after the corosion wore away

Other than that it is not recomended without a permit though this sways few people- It is a very memorable moment driving youre beast off the docks :)

Thanks for your responses guys!

I don't mind getting a tow, but a friend who tried to get his MR-2 towed got refused because the tow truck driver didn't think he could do it without damaging his (stock) front bumper. I just wanted to check if it's relatively safe to drive it back from the docks if that was the only option I had. I certainly would be driving it slowly and safely in order to avoid any damage. It's probably a bit over the top to do an oil & filter change on the spot, so I will most likely check fluid levels etc. make sure everything checks out OK then drive it very sedately home.

I can't wait :(

You wont damage it by putting it on a flatbed. My front bar sits so very low and there were no problems at all. I highly recommend doing that and transporting it to you destination.

If you book a flatbed truck the day before you go down then you are likely to get a better rate too.

my battery worked fine and the car had been sitting for 6 months prior to shipping, so it wont DEFINATLY be dead, cos mine wasnt, but your right its very very likely. and your also right about the brakes, they were ****ing awfull on the drive home, still safe enough taking it slowly, but shithouse all the same

Yeah my car started first go too. But my battery is quite new. On an older car its less and less likely to happen.

I went the tow. For $80 it saved me all the hassles listed above, having to drive an unknown car, and any worries about breaking something.

For peace of mind, it was well worth it IMHO. Compared to the cost of the car its nothing anyway.

LW.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...