Jump to content
SAU Community

Recommended Posts

I bought the innovate lm-1 kit to tune the afr with the datalogit.

It interfaces easily to one of the 0-5v analogue inputs and allows you to plot average afr for each load cell. Very easy to tune with.

I do the same with the tech edge...also too easy.

Hey BMX, hows the wrx catch can?

After finishing the current tank of fuel I was on I managed to travel 402km's on a full tank. This is a significant increase in fuel economy. The wideband tuning was done when my fuel tank was just over 1/2 used and the ODO was on approx 220km's when we had finished wideband tuning. I usually get approx 330km's to a full tank.

I will see how it goes next week as I have just filled up today. I expect around 450km's to a full tank which is a massive improvement.

Thanks to all of those who have offered help and assistance.

The PowerFC guide will be updated in the next few days to include the wideband on road tuning and how to do it.

Paul I reckon your problem lies somewhere else. The stock ECU and Powerfc should give about the same fuel consumption if you dont hamer it much. You wil be in closed loop most of the time - relying on 02 sensor reading.

Are you getting around 14.7AFR at idle and whenever car is in closed loop?

I was getting about 400-450km to a tank (about 11-12L/100km) without the powerfc tune. When stuck on the dyno the AFR went into the 9s at full throttle.

Since the tune I got about 460km to the tank (10.6L/100km) but I reckon if I stayed off the gas then I don't think there would be any difference in consumption. The timing down low doesn't give you much benefit in fuel economy. I think a wheel alignment might give you more if you have too much toe.

You should check your injector duty cycles and air flow voltage at say 60km/h, 70, 80 and 90 in 4th gear (on the flat) and compare them with others on here.

Maybe you just sit in bad traffic or have a lead foot!! hehehe

no i wasnt getting 14.7 under normal closed loop, the whole close loop imho is a bit of rip i think, it takes so long for the stocky 02 sensor to give anything useful to the ecu about the afr's almost not even worth having it on.

when ive done a full tank im gonna turn off 02 feedback.

with proplerly tuned afr's i dont think 02 feedback will do anything other than waste calculating power. ive never had good economy on the FC until now, when i tuned the INJ map with a wideband sensor. before then it was always average is 320/330/340. on a full tank of fwy i would get maybe 400 if i was lucky. never ever ever over.

stock ecu economy was ok ish, not super great. not over 400 thats for sure

i do mild spiritied driving some of the times but the majority is light load / cruise. my inj duties however around 1.8% 2.2% on light cruise

I just came back from Bendigo taking it easy and i got 390ks before the light comes on. I generally can push this out to 450 before i fill up (love running it on empty) Last tank 434ks. I was quite dissapointed with the open road cruising as i took it easy and was only gettting 100ks every quarter of a tank. When we tuned it we concentrated alot on fulll throttle but didnt do much on light throttle since upping the fuel pressure so i guess its guzzling on light throttle. Im smoothing out the part throttles Inj cycle to try and bring a little more effeciency into it. Even with the bigger turbo i think i could still get 500ks on a trip but might need a dyno to see my AFR's at light throttle.

Im experimenting at leaning it out a little on light throttle but its all guess work until i get a monitor. Remember i could only be adjusting it 1% here and there so its really not going to make much. I hope i dont lean it out too far.

about to upload my current tune data and .dat files and also got the datalogit afr chart in excel so i can spit out my afr's apparently based on what the pfc inj map values you are (so it claims anyway)

attached fuel inj compare against last tune and also fuel map and also datalogit tune .dat file. rename .txt to .dat and use it with datalogit if you wish

post-2054-1138879080.jpg

post-2054-1138879124.jpg

paulr33_193rwkw_widebandtuneup.txt

thanks Robo for pointing that out, something i clearly missed.

I managed to get 504k's to a full tank of all hwy driving on the weekend,

This week is city testing, so far 100k's on just under a 1/4 of a tank.

Will update those 3200rpm cells, should be 1.00 instead of 1.070

I was getting about 400-450km to a tank (about 11-12L/100km) without the powerfc tune.  When stuck on the dyno the AFR went into the 9s at full throttle. 

Since the tune I got about 460km to the tank (10.6L/100km) 

460km to the tank at 10.6L/100km would suggest that you have only a 48.76L fuel tank.

To properly work out fuel economy you need to start with a full tank, resest the trip meter drive how ever many Km's you want then refill tank to full and compare your actual Km's travelled to the amount of fuel you needed to fill it back up.

My around town fuel consumption for my PFC tuned 25t is 15L/100km which would be 433km's on a tank (65 litres) full to empty.

I did the fill up reset the trip, then fill up again to get those readings. Thats the only accurate way you can do it. Not everyone is going to run it dry..I ran it till almost E and got 460km - no doubt plenty left - yes I put in close to 49L. You probably will never run it down to less than 5L unles you really push it.

15L/100km is horrid. To be honest though I havent really done much heavy traffic driving - I guess mine would probably go to 12-13L/100km then. They are only a 2.5L engine. If u use boost a lot then expect bad consumption.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hi 🙋‍♂️. Just bought my Unicorn but the interior need some minor work so it would match my expectations ;). I noticed it is hard to get used oem floor mats in good condition so i started to dig if there's any chance to buy set of new ones. I found two websites - nengun and amayama and it looks like one can still buy factory new floor mats in Japan, but thers a small issue. Some mats (i assume genuine, oem ones) are marked as G4900 and these are "discontinued". The ones you can buy are marked as G4911 but i have no idea if these are also oem, made by other producer or some lower quality replacements that looks entirely different. Can anyone help? 😃  P.s. there is also some strange indication - 0V005, 0V015 and 0V505. Any idea what does it mean? Would appreciate any help with this 🙏
    • Hi, Marek here 🙋‍♂️. I finally fulfilled my longtime dream - recently bought Stagea and now waiting for it to arrive in Poland. There's only few of these in my country, and one of the owners  recommended mi this forum as a source of all the info i'd need since now i own one  so here i am.  
    • Version 1 aluminium airbox is.......not acceptable No pics as I "didn't like the look.....alot" Even after all my "CAD", and measurements, the leg near the fusebox just didn't sit right as it ended up about 10mm long and made the angle of the dangle look wrong, the height was a little short as well, meh, I wasn't that confident that Version 1 was going to be an instant winner I might give Version 2 another go, there's plenty of aluminium at work, but, after having in on and off a few times, and laying in the old OEM airbox without the new pod filter and MAF, there may be an option to modify the OEM air box and still use the Autoexe front cover and filter.... maybe This >  Needs to fit in here, but using the panel, and not the pod, the MAF will need to fit in the airbox though> I'm thinking as the old OEM box and Autoexe cover that is sitting in the shed is just sitting around doing nothing, and they are relatively abundant and cheap to replace if I mess it up and need another, it may well fit with some modifications to how the Autoexe brackets mounts to the rad support, and some dremiling to move it get in there, should give me some more room for activities, as I don't want to move the MAF and affect the tune Sealing the hole it requires to stick it in the air box is simple, a tight fit and some pinch weld will seal it up tight  I am calling this a later problem though
    • and it ends up being already priced in as though you're just on 91RON without any ethanol. Car will lose a bit of economy as the short and long term fuel trims bring down the AFR back to stoich or whatever it is for cruise/idle for the engine.  
    • Oh, you are right. But, in Australia E10 is based on 91RON fuel and ends up being 94RON. Hence it being the cheaper option for economy cars. The more performance oriented cars go for the 98RON fuel that has no ethanol mixed in. The only step up we have left then at some petrol stations is E85.
×
×
  • Create New...