Jump to content
SAU Community

Recommended Posts

I know the twin turbo 3ltr sequential twin turbo supra has a lot of potential. But I was just wondering if anyone knows what rwkw are achievable with the following mods

- After market cooler

- Power FC or equivalent

- full exhaust system from turbos back.

- boost increase with stock turbos

From reading these forums and from personal experience these mods on a RB25 with 10-12psi of boost ~200rwkw seems to achievable. I know the supra will make a lot more power than this but how much more?

Edited by Munna
Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/
Share on other sites

  • Replies 46
  • Created
  • Last Reply

Top Posters In This Topic

Well.. when we were at the dyno day with OCAU a supra running pretty much the same setup except it was running a SAFC2 and a boost controller I believe.. he reeled off about 240kw..

Thanks thats about what I would have expected anyone else? What 1/4 mile times would a supra with these mods and a good suspention setup get?

Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/#findComment-1623994
Share on other sites

My brother has a '95 Supra RZ with those mods, plus a Trust pod filter, Bosch 044, AVCR and a Malpassi fuel pressure regulator and is making 272rwkw at 14psi. He could be making a little bit more, but needs a new dump pipe.

"They taste like burning!"

Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/#findComment-1624554
Share on other sites

The dump isn't stock; it's a 3 inch dump. But he was told that a 3" dump was too large for the stock turbos on a Supra as the wastegate can't control the boost properly (needs the back pressure). So he's had a restricter put into the dump until he gets a new one.

"They taste like burning!"

Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/#findComment-1624659
Share on other sites

Got a friend who got there 1996 TT (6spd) Supra dynoed with the following setup:

1. Aftermarket Front Mount Intercooler

2. Stock Air box/Turbos/Boost setting 10psi or there abouts

3. Catback- OR turbo back exhaust (unsure)

4. 18" rims.

result:

214rwkw at unigroup.

Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/#findComment-1624706
Share on other sites

2JZ-GTE into an R33 is stupidity in my opinion. 2JZ with the 6 speed costs an absolute fortune, and an RB26 can make similar power. If you really want the BIG CUBE straight six, you could probably build a killer RB30DETT for less than a 2JZ engine swap. The cost of installing a 2JZ would be phenomenal.

Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/#findComment-1624976
Share on other sites

Keep a Supra engine in a supra, and an RB in a Skyline..

If you want extra power in a Gts-t.. go and buy an R32 GT-R than you'll even it up.. what a skyline lacks sometimes in raw power, it makes up for round the corners.. ATTESSA.. and a couple of other areas..

Personally I would love a Supra TT - but for 40k i'd be hard pressed to not buy a R33 GT-R..

They are definately quite a nice car.. I love the look of them.. so sleek.. with a set of rims, lowered with no wing.. droooolling..

Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/#findComment-1625025
Share on other sites

Thanks everyone I know that the supra is quicker over the 1/4 than the r33 gtst from the factory.

How would a R33 GTS-T fare against a the supra both in street trim at this level of modification assuming they both have a decent suspention/tyre setup. Keeping in mind the supra weighs 200kg's more.

I know that the skyline is capable of high 12's what can the supra do?

Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/#findComment-1625140
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
    • Yeah mate, never miss it.
    • Any going to watch World Time Attack at SMSP this year?
    • Appreciate the correction on the "ground", that will make a huge difference to looking at this. That makes complete sense about AF70/AF71 which is what I had come down to being the issue, one of these. I'll have another look in the ignition wiring when I get a chance next week. I'll also make up a jumper wire for running that AF73 test.  ECU is fine, relay itself is fine, pump harness is fine and the pump itself is fine. I am going to upgrade the Walbro 255 anyway with a DW300 I have since I need to replace the fuel sender and I'm going to upgrade the FPR with my chasebays kit ready for new plenum/injectors/dbw, but I'll get this working first. That's why this is so frustrating. 
×
×
  • Create New...