Jump to content
SAU Community

Recommended Posts

I would suggest using electronic cleaning solvent for the afm as it is a fairly sensitive hot wire element in it, spray it leave it for 10 min and do it again just to make sure its cleaned properly wait 10 min before driving . It works a treat as I have used it on both of my cars & my sisters atmo R32

Questions:

How far away do you spray from (don't want to damage the element)

Do you only spray the element or the inside of the AFM casing as well?

How do you know when it's clean? Do you shake it around and watch crap fall out?

Depending on how much oil there is in your intake pipe you may wish to spray with your AFM still attached. Generally I just remove the AFM and clean it separately. You can always remove the intake piping and clean it off the car if you want.

Run your finger around the inside of the AFM. If it's oily, then it could probably do with a clean too.

I use CRC Contact Cleaner. Hold it about 15-20cm from the AFM, and spray in the direction that air passes through. May need to give it a few blasts if you have a lot of oil.

Once it dries (about 30 sec) you should be able to run your finger inside and see that it is clean.

You shouldn't see stuff fall out of it. Generally oil will just stick to the element and the inner plastic.

  • 2 weeks later...

Thanks, I've always wondered :D

but wtf is the AFM

Air flow meter - it basically measures how much air passes into your engine. It's the main input for the computer and a hell of a lot of decisions are made based on that input. Basically if you find the air filter in your car and follow the pipe a little back you should see a piece of "pipe" with some flanges on it and a plug coming out of it. That's your AFM.

Don't use Carby Cleaner on the AFM it leaves a residue afterwards. Use Brake Cleaner or Electrical contact cleaner instead.

Do it on the car if you can get to it, just spray the actual senor wire the rest of the assembley doesnt matter.

Weasel the AFM is after the air filter it is a piece of wire and plastic sitting in the middle of the intake pipe. If it gets dirty it can give incorrect readings to the ECU resulting in missfires

What Duncan Said,,,"Brake Cleaner". It's my mechanic in a Can. Cleans AFM's,,,funny enough brakes (removes spilt brake fluid as well as cleaning brake grunge. This stuff SHOULD be in everybodies toolkit.

I even use it to clean up his oil seepage between races.

If you really want to do a test,,,get a clean piece of glass and spray some carby cleaner,brake cleaner and contact cleaner on it, one at a time and you tell me the results.

Neil.

  • 3 weeks later...

haha. when i cleaned my AFM i used CRC contact cleaner. didnt need much, endded up taking it back. scored $20. booya

i cleanded it too much, long story short. my car was running better when the AFM was dirty (as my car was rooted). so for no reason i decided to try dirty it again... used everything i could find under the sun, as long as it was spray-able. however it wouldnt go dirty again.

anyways got my initial problem fixed and now the car runs fine, with my poor attempts to dirty the AFM.... id clean it again if i didnt have to go back to the shop to get a can of cleaner

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...