jhjones

The car did 10 laps around the track before I noticed oil all through the intercooler piping, no catch can at the time. Did a compression test, 155-160 on all six.I installed a catch can and noticed it filled 1 litre with just hard street driving and one night at the drags. Did a compression test and cylinders 1,2 dropped down to 115, and 130.

Hi, my engine recently dropped compression on 2 cylinders and I suspect cracked ringlands due to the smoke and blowby. I was wondering if someone could have a look at the tune on the ECU and give feedback on it. Thanks. RB25DET, stock turbo 12psi, Link G4 http://www.mediafire.com/view/5dd7jagfhxsuz51/skyline.pcl

Should be around be around -20 inhg if stock cams?

Easiest would be bolt the r33 intake on to the neo, use the r33 ecu, loom, swap vct plug and reverse cas wiring. Think that's it. Should run good.

Can the slave cylinder piston be pushed back into the cylinder? RB25 release bearing carriers are different to RB20.

Clutch fork is the same. Not the release bearing carrier.

These

Both the bolts for the front uca are different diameters. Larger diameter bolt is the inner. Inner bushes are slightly longer too. That should tell you what way they fit.

You can just go to ENZED to buy a tee and barb fittings.

Another thing to check is if you put the calipers on the right sides, bleed nipple at the top.

Got a boost gauge?

drivers side rack seal, pipe or governor.

adjusted the clutch pedal?

Over tensioned belt?

http://www.skylinesaustralia.com/forums/topic/146509-r33-boot-stuck-shut/

Hard to put in first while the car isn't moving? If so then the clutch isn't fully disengaging. Check pedal box, clutch hydraulics first.

I think its normal because steering column should slide down and go under the dash if you hit it in a accident.

gktech solid bushes.

Shouldn't ecu be in open loop at idle and closed loop on light throttle, cruise?

maybe coil loom?

Yours has 5x1 axles too?

Is that R34 helical? http://www.trademe.co.nz/Browse/Listing.aspx?id=608558403

Could be a bad connection. I aussme the battery terminals are clean?

don't think you need to mod crossmember for auto r32