Jump to content
SAU Community

Recommended Posts

Does anyone have pics of a R32 GTR (Gunmetal grey) with R34 GTR rims?

I have found every other possible colour except gmg... its annoying.

I wanna see if the two colours will go together.

These pics are not very big, but they all I got in gun metal grey 32's with 34 gtr rims:

1071375_medium.jpg

r32_gtr_mean.jpg

And if you want my opinion I reckon the rims work really well with that colour 32!

Edited by r32line
What you done to the car Abu? Engine mods etc. I'm looking at getting twin cannon set up.. I just love the look.

Show us your new GTR :)

Car still has most of the below parts, some have been taken off as its been sold off

Apexi Power FC

Apexi AVCR

HKS cam gears

HKS2535

HKS dump pipe

HKS front pipe

Custom cat back twin canons

Blitz intercooler

BOSCH 040

GTR injectors

Z32 AFM

Tein coilovers

KAZAMA caster rods

EXEDY button clutch

Emotion XD9

Was around 205wkw on a safe tune, went good

No pictures of the GTR yet, will get some next week but won't be in this section unfortunately.. lol

clean 32 4dr mate :)

you sure its a genuine front bar? coz you will need gtr guards for it to fit properly cause gtr front is wider then gtst

nah you dont need GTR gaurds to make the front bar sit nicely, simply redrilling/grinding 2 wholes in the GTR reo bar (12mm to be exact) will bring the front bar foward enough to fold the sides of the bumper up to the gaurd leaving no gap and over hang :P

spiudf.jpg

14cv793.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yes the gear for the R33/34 is different, it is red and has a different number of teeth. My part didn't come with that gear though, so I don't know how many teeth are on the red one. You'd have to reuse the 260RS/R33 gear, as long as it's not destroyed.   Haha, as unfortunate as that might be it was working fine for about the first 1500km I've had the car for now.
    • Update all   thanks to the workshop manual, it lead me back to checking fuses as mentioned central locking and door open lights worked when acc was switched on. diagram attached shows two points of power 1. ACC and 2.  Batt with the later being fused (#28) I did check the fuses using a multimeter but I must have stuffed that up also. Went back and checked the batt fuse in interior fuse box and you wouldn’t believe it… a blown fuse. replaced fuse and everything is now working as it should including the climate control   thank you all with your positive insight and knowledge.    
    • Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
    • Thanks GTSBoy, much easier to work with it now it's free!  
×
×
  • Create New...