Jump to content
SAU Community

Recommended Posts

  • Replies 418
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

I'd hate to see your high volume ones... well... actually i've seen supposedly two of them.

And one was hugging the bowl :)

if i rember corectly you were chucking it up in the dunnies and i was sober enough to knock back a shag fom a fat chick

so we still had 40 beers before we were pissed

im in just to slap nismoids arse a few times pretty boy

Well,

I have sat on the side line for a while on this one.

GOD DAMM! A Wednesday? you know how to entice people dont you!

Im a maybe definite but could be a perhaps not sure little chance almost 100% going to be there!

Everyone get that.

My 10c is that if any car from Sydney gets within 5 seconds of the quickest 2-3 Vic GTRs then they are doing a pretty good job.

I will be happy to get the feck out of no good Victoria. NSW cars are cursed down here :D

Roy, thats a big call, the guys need to run almost V8 super car times to be 5 sec better.

My light tuned GTR has hits the 1.09's so they better be coming to drive hard!

check that

4 way with a fat chick

I was about to say... dont tell me finer details had been forgotten.

And mark was off his chops. Dont put the "we" in there, he chundered in that club after the pub :P

Well,

I have sat on the side line for a while on this one.

GOD DAMM! A Wednesday? you know how to entice people dont you!

Im a maybe definite but could be a perhaps not sure little chance almost 100% going to be there!

Everyone get that.

Yeah mate a Wednesday, should be PLENTY of track time for the $$$

Hahaha, you've confused me with the

Im a maybe definite but could be a perhaps not sure little chance almost 100% going to be there!

but ill assume you're in :)

Roy, thats a big call, the guys need to run almost V8 super car times to be 5 sec better.

My light tuned GTR has hits the 1.09's so they better be coming to drive hard!

Like i said, 5 seconds :)

Im hoping to be doing 1:08s in my car, though i will happy with a 1:09. There are cars coming that have done 1:06s in the damp with only a few laps under their belts. Hell even Snowball did a 1:07 with a crook engine. So like i said, andyone getting within 5 seconds of them will be doing well. As im guessing there will be cars doing 1:04s and 1:05s :)

Friggin cheater cars, i remember when a 1:10 was quick at Wakefield because noone ran mods and semi slicks ;)

BUT, who really cares. Let shope we get a good number of ppl out having a good time...and we are able to witness some top notch cars crank out some scary speeds. I know im goignt obe there with a video camera to catch it all.




  • Similar Content

  • Latest Posts

    • Yeah well per the video it took 15s for the stock unit to start up....even if I give it a few seconds discount for starting that is at least 12 sec before you get a reverse camera if you are trying to leave a park.  The android unit is way faster, but 2016 for the stock unit is a long time ago in consumer electronics
    • Yea that’s why I said ima test them with multimeter and see the reads.
    • Only at idle. Isn’t a problem when rev it seems.
    • @Haggerty This seems silly to ask, but are you confident in your ability to tune the Haltech?  
    • Next on the to-do list was an oil and filter change. Nothing exciting to add here except the oil filter is in a really stupid place (facing the engine mount/subframe/steering rack). GReddy do a relocation kit which puts it towards the gearbox, I would have preferred towards the front but there's obviously a lot more stuff there. Something I'll have to look at for the next service perhaps. First time using Valvoline oil, although I can't see it being any different to most other brands Nice... The oil filter location... At least the subframe wont rust any time soon I picked up a genuine fuel filter, this is part of the fuel pump assembly inside the fuel tank. Access can be found underneath the rear seat, you'll see this triangular cover Remove the 3x plastic 10mm nuts and lift the cover up, pushing the rubber grommet through The yellow fuel line clips push out in opposite directions, remove these completely. The two moulded fuel lines can now pull upwards to disconnect, along with the wire electrical plug. There's 8x 8mm bolts that secure the black retaining ring. The fuel pump assembly is now ready to lift out. Be mindful of the fuel hose on the side, the hose clamp on mine was catching the hose preventing it from lifting up The fuel pump/filter has an upper and lower section held on by 4 pressure clips. These did take a little bit of force, it sounded like the plastic tabs were going to break but they didn't (don't worry!) The lower section helps mount the fuel pump, there's a circular rubber gasket/grommet/seal thing on the bottom where the sock is. Undo the hose clip on the short fuel hose on the side to disconnect it from the 3 way distribution pipe to be able to lift the upper half away. Don't forget to unplug the fuel pump too! There's a few rubber O rings that will need transferring to the new filter housing, I show these in the video at the bottom of this write up. Reassembly is the reverse Here's a photo of the new filter installed, you'll be able to see where the tabs are more clearing against the yellow OEM plastic Once the assembly is re-installed, I turned the engine over a few times to help build up fuel pressure. I did panic when the car stopped turning over but I could hear the fuel pump making a noise. It eventually started and has been fine since. Found my 'lucky' coin underneath the rear seat too The Youtube video can be seen here: https://www.youtube.com/watch?v=uLJ65pmQt44&t=6s
×
×
  • Create New...