Jump to content
SAU Community

Recommended Posts

Kakimoto is quiet. There was one on the FS within the last couple of weeks. I'd buy that if I still had a car - my favourite muffler for a road car.

Fujitsubo is also known for being quiet.

You might wanna put your setup now - there might be a cheaper way.. i.e. if you have a hot dog and cannon then the easiest way to make it quiet would be putting in a mid muffler, it would be cheaper and might sound good.

Good luck.

Go to your local decent exhaust shop and ask them to replace your rear muffler with a Magnaflow oval muffler and a mid oval muffler also. The noise is made by the internal design of your cannon/mufflers.

I changed from a jap exhaust to a custom cat-back and the difference in noise was astonishing, no more drone, popping or headaches just a constant quiet RB26.

I have a 5Zigen oval muffler & literally cannot hear it over the tyre noise. Dunno is you want it THAT quiet, however.

By the way it has a JASMA plate on it starting with 92-. not sure if the 92 in some way refer to the dBA rating.

Edited by djr81

I had a 3 inch Nismo cat back with the middle 'muffler' and oval rear muffler and 4" tip, picked up 2nd hand for $350 from an importer.

It was as quiet as, prob a little too quiet - i.e. did a 5000 rpm launch with cops on the other side of a van beside me and when they pulled me over they didn't mention one thing about the exhaust, only how fast I took off. No tyre squealing tho(32-GTS4)so that probably disguised the speed of the takeoff a little as well as the quiet exhaust .

Didn't even get a ticket so I am glad the exhaust was quiet.

Edited by gts4diehard
  • 4 weeks later...

I just fitted an HKS Silent Hi Power cat back, i was dubious about the silent part as i could see straight thru it and my daughter could fit her whole arm inside it. once fitted i was impressed, it achieved all its goals.

At idle it still sounds a little herby (i have cams), but on acceleration and deceleration it silences quite well, with little to no restrictions.

overall - impressed.

Most aftermarket systems are over the 90DB legal limit.I have a fujitsubo system.Which is really quiet.

However i managed to get defected for it.It was 94.6DB.The standard system i have on it now is 88.5DB.

The fujitsubo Legalis R system is 89DB at 4500RPM.That would be the system id recommend.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi. This is just my curiosity because iam sure the tuner figure something out...but either way i want to ask. The "problem" is that the Nistune ECU (Stagea FW and RB25DET NEO from Stagea) sees many times the speed than the speedo does(he says the speedo show 120 km/h - correct speed and the ECU shows like 510km/h ) I told him that this car/tranny getting speed from rear diff. If iam not mistaken the RB25DET NEO "need" to see tranny speed sensor? (my tranny has the plug for it). So couple of "question" If he connects/wire the speed sensor to the tranny...are the signals gonna intervene and if...what if he disconnects the rear diff one and the speedo stops working? Or the "new" sensor from the tranny "take over" and will not going need the one from diff? As i said i know he figure/get that done...iam just curious to know what are the solutions 🙂 
    • Your IACV is set to idle too low. You need to adjust it via the screw Duncan mentioned. From memory it should be 650rpm with the valve electrics unplugged. What is it trying to idle at with the IACV plugged in?
    • Ahhh, I need the whole head unit. I definitely needed to roll back through and review your setup, ha ha! Neat setup they have going on. I just need a full double din head unit. But I want good and responsive. I might have to review what the likes of pioneer have out these days.
    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
×
×
  • Create New...