Jump to content
SAU Community

Fuel Pump Poll  

281 members have voted

You do not have permission to vote in this poll, or see the poll results. Please sign in or register to vote in this poll.

Recommended Posts

Jason,trust Nengun as I have bought some things off them that were quite expensive and always turned up.Including the Nismo pump and am wrapped in it.Quiet,strong flow,and has all wires attached with it`s own frame.Simply pull the old one out and throw it away as the Nismo is complete.

Yea thats the main reason im wanting to get a nismo fuel pump, i had a gtr fuel pump in my old r32 gtst and everyone said it would be a straight bolt in, but it turned out that i needed to modify the bracket and filter bag, was a pain in the arse, so ive decided to spend a little bit extra this time and go for something that will bolt in with no hassles, i think i will place an order with nengun soon (might also get a blitz lm fmic kit and a few other bits and peices) everyone seems to trust them and ive never heard of anyone having a problem with them so thats good.

Cheers mate

  • Replies 65
  • Created
  • Last Reply

Top Posters In This Topic

1) Bosch 040 - internal

2) 33 GTST, mild mods, std turbo, approx 200kw

3)

- Ease of installation: pain in the ass to get the fuel new pump back into tank.

- Noise level in cabin: no extra noise

- Starting issues: need to prime sometimes but no dramas.

- 1/4 tank syndrome: none. Because I modified the bracket so that the intake sits in the same place as where the stock sock did.

cheers

1- r33gtr pump

2- 33gtst exhasut,air intake,boost controller under 200kw

installation was not too good as i couldnt use the r33 rubber mount on the gtr pump so i took it to a workshop and they did it (dont know if they used anything to be honest)

noise level is ridiculous... loud when priming, softer when idling but still audible

no starting issues

1/4 tank syndrome not sure as i just installed it

cheapest and ok for up to under 300kw would be either a walbro one or a 33gtr one both can be had for about $150 if u know where to look

bosch 040 is good too but i think isnt rated as high as the above 2

someone correct me if im wrong and they are around the 200 mark

1. Walbro lift pump tp swirl pot. 2 x bosch 910 280LPH @ 5bar direct voltage feed. New 3/8 fuel lines and fuel pressure gauge in dash standard FPR

2. R32 GTR track car stock turbos, injectors ( not for long ) PFC pods etc. Installation was not to bad as swirl pot in the boot

3. Sounds like a group of migets belting seven shades of shite out of the back of the car. Very glad for very loud exhaust and helmet.

4. no issue with 1/4 tank stuff with swirl pot.

yer id also like a definate answer about the 040, Im looking to run close to 300rwkw with some love juice (c16) and daily 260-280 on PULP, the 040 is rated at a 500hp pump, I just dont want it on edge when running near 300rwkw

Then theres the option of 044 (internally) Dont really want a swirl pot and ext pump....

This is on a 20 BTW

-Jez

  • 3 years later...
  • 11 months later...

Thread dig.

I've recently purchased a bosch 044 already setup in the factory cradle from a 32 gtr to go in my 32 gtr. just want to know if anyone has had any problems with having these mounted in-tank at all?

Need a piece of advice...when installing aftermarket pumps do you need a Fuel pressure regulator? When does one need an FPR????

Cheers

Pretty much never unless you are too stooge to get big enough injectors and compensate by increasing rail pressure, that or you are running some stupid hp and decide a rising rate makes things easier to tune.

  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...