Jump to content
SAU Community

Recommended Posts

Hey Shell,

faxed the form a couple of days ago, and put payment through 14/05.

Let me know if nothing comes through in a few days.

hey Bobby, got the form have just added you to the members section... btw, you're $5 short on the membership fee :)

WPN-033, it will be sent off to you on Friday :thumbsup:

got me replacement card in the mail yesterday! thanks so much for doing that for me i owe u one lol, now i caqn go discount shopping, want a new turbo for your troubles hahaha

  • 3 weeks later...

Quick question on membership renewals...

orry if its been covered elsewhere...

I forget when mines due but does the club send out the inof a week or 2 before the renewal date?

cheers,

Chris

  • 2 weeks later...

Shell, my membership application form has been faxed and the money was deposited online yesterday afternoon. as both my account and the sau's account are national, i assume the fund should have been cleared instantly. could you please confirm?

thanks :P

  • 2 weeks later...

hi i joined the club at the show and shine i was curious as to how my membership is proceding as i havent heard anything as yet regards mike

Edited by mike40sydney
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...