Jump to content
SAU Community

Official Sauwa Cruise - Perths Most Haunted Places- Oooooooo


Recommended Posts

  • Replies 412
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

hey everyone.. yeah i don't know any of you but i'm hoping to meet you all this friday.. i'll come to the woodvale meet up point.. i don't mean to brag but i do know a LOT of people in perth so maybe you'll all pop up and be like "HEY I KNOW U! " 9pm meet up? i'll be driving a green hyundai excel ^_^ by the way.. you should all seriously exchange phone numbers it works well

and i'll try get some chosen few members down :) cuz im not supporting any club on friday simply why im driving the excel out hehehehe

*edited*

Edited by dan_the_man
ok cool.. and with the UHF ch 18 is that just the little hand held wlakie talkie things???

Yeah you can get full units that fit to your car but hand helds are probably better and easier for this type of thing. I got 4 from dick smith for about $150 or something. I think single is under $50.

Just make sure its UHF band and not AM, or it will be useless to you.

On the the question about the police. I have been on several cruises where they meet at the meet points. Never seen them issue anything. They normally drive around, talk to a few people, have a look around to make sure no one is doing anything silly. As long as its all good, they will leave with no problems at all. Unfortuantly as soon as 1 person does something stupid, they get a bit upset. I think hillarys was different due to the large amount of fools/racecar drivers if you know what i mean.

Yeah you can get full units that fit to your car but hand helds are probably better and easier for this type of thing. I got 4 from dick smith for about $150 or something. I think single is under $50.

Just make sure its UHF band and not AM, or it will be useless to you.

Hey Brad what are you doing with the other 3??? Do you see where I'm going with this!!!??? :P

Hey Brad what are you doing with the other 3??? Do you see where I'm going with this!!!??? :wave:

HA HA i think i can see where your going with this. Im sure if you buy the batteries, i could possibly lend you one.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I wanted to try and preserve the front bumper as long as possible, they're not cheap and are made to order in Japan. Taking inspiration from my previous K11 Micra build where I made an undertray for the Impul bumper, I did the same for this BN Sports bumper but a little slimmed down.  This time round I only made a 'skid plate' (if that's the correct wording/term) for just the bumper surface area, the Micra version covered the gap like an undertray. Starting off with a sheet of mild steel approx. 0.9mm thick 4ft x 2ft in size. I traced around the bumper, cut it out and cleaned the edges. Luckily I was able to get two halves from one piece of metal In the video I installed it as is, but I've since then I've removed it to spray and add a rubber edging trim. The rubber trim is suitable for 1-2mm and it's a really nice tight fit. The bolts had to be loosened due to the plates being too tight against the bumper, the trim wouldn't push on I used some stainless M6 flat headed bolts for a flusher finish (rather than hex heads poking down), I believe this style fastener is used for furniture too incase you struggle to source some. The corner's are a little wider, but this may be an advantage incase I get close to bumping it  The front grill got some attention, finally getting round to repairing it. Upon removal one fixing pulled itself out of the plastic frame, one side is M8 that fixes inside of the frame, where as the other side is M5. Not knowing I could get replacements, I cut down an M8 bolt, threaded it inside the frame along with a decent amount of JB Weld.  The mesh was replaced to match the bumper. One hole on the bonnet/hood had to be drilled out to 8mm to accommodate the new stud, once the glue had set it could be refitted. I think the reason the grill was double meshed was to hide the horn/bonnet latch (which makes sense) but I much prefer it matching the bumper Bumper refitted and it's looking much better IMO The Youtube video can be seen here: https://www.youtube.com/watch?v=bVZP35io9MA
    • The video for the servicing and fuel filter change can be seen here: https://www.youtube.com/watch?v=uLJ65pmQt44 One of the main jobs I wanted to do before the car officially went on the road, was to remove the awful looking blue silicone hoses. There's nothing wrong with having coloured silicone hoses, but I realise as I'm getting older I prefer monotone engine bays with a splash of colour on the engine cover(s). I cover this in a lot more detail in the Youtube video, so unfortunately there's limited photos of the process. The intercooler, upper radiator, boost vacuum and upper breather hoses were all changed to black silicone with mikalor clamps. The only blue left is a blanking cap at the back of the inlet manifold and the GReddy pulleys (which will be replaced for stock when the cambelt gets replaced) While the intercooler pipes were off I gave them a quick clean/polish too A before photo I do have a replacement air filter on its way. Fuse box covers were painted blue, they're now satin black Another job on the list while the bumper was off, is to add some mesh https://live.staticflickr.com/65535/54737966256_99b28bfa30_c.jpg[/img] I was hoping to use some thin wire to secure it, but it seems I've misplaced it and the wire I had was too thick to twist easily. I ended up using cable ties for the time being https://live.staticflickr.com/65535/54737131882_c2b7989dcc_c.jpg[/img] Was pleasant to see this https://live.staticflickr.com/65535/54737131627_8b2aab13b3_c.jpg[/img] The last thing to do was to fix the front grill and re-mesh that to match but I ran out of time The Youtube video can be seen here: https://www.youtube.com/watch?v=R4FsF6tgizE&t=23s
    • Hi all,I already introduced myself in the Victoria section, but only saw this section now lol XD New to forums and new to skylines. Hoping to buy my new skyline within October
×
×
  • Create New...