Jump to content
SAU Community

Sauwa Friday Night Cruise *** Friday 10th August***


Recommended Posts

  • Replies 357
  • Created
  • Last Reply

Top Posters In This Topic

same reason girls have sex with you... they know you are going to come first but they still have fun anways

jks big boy :laugh: hugz

HAHAHAH coming from the two second man HIMSELF! I don't carry a rep for it brother wink.gif MUCH love hahahaha :)

Edited by jazza08
30 Arent they generally bigger than that?

Suppose smaller is better, less cop attention maybe

yeah cause of the rain

smaller crowd is better as we can all swap partners and not missout on anyone... too many on the charity cruise I only managed about 1/3 of the ladies (I think they were ladies) :)

line me up just once ricey :P just do it... haha

ps... r33 gts-t's on wet sau cruises have a LOT to live up to. see if we can have a record amount of spin outs tonight

nah man i wanna be as far away as possible when fragments of driveline start flying in all directions hahaha

you're a bit of an angry kid aren't you?

should be some fun tonight, I suspect the X3 will chop you all from the lights....

he still holds the grudge of getting chopped by a stock rb20 with antilag.com sticker on back

Have decided against coming tonight - need a new set of rubber and can't get them till next Friday. Should be a decent turnout though. Have lots of fun ppl :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...