Jump to content
SAU Community

Recommended Posts

  • Replies 90
  • Created
  • Last Reply

Top Posters In This Topic

the driver was hitting the limiter before he took off and creeped up forward... then the official sort of lost it and told him to move back... then he revved dumped like he just stole the gtr went left right left right until it looked like he touched the brakes and ended up smacking the rear end mostly on the other side.. maybe he shit himself and got nervous on the track :kiss: does insurance pay for LEGAL drag racing...

and btw CRAKED why werent u racing ur car!.. remember i was going to swap u the bonnet and boot at safs.. i own that white r33.... saw ur car in the car park looking lonley.. shouldve been on the track champ!

Insurance will not cover the damage even though he asked the question of the officials at WSID. :kiss:

The official didn't lose it at him at all, btw. He directed him to roll back through the beams as he had crossed them with his front wheels.

lol, from up top the official looked frustrated because people dont realise that they have a certain mark where they have to stop, thus why the chrismas trees have the 2 top lights that tell u to stop, they should have a sign that displays STOP WHEN THE 2 LIGHTS FLASH or something,

and i think it would be awesome if they had a big screen tv with replay action :kiss:

yeah big screen action reply would be a winner. considering each race only lasts 12 seconds or so and it takes a minute or two between runs some nice replays would be cool.

Hate to say it but this tool deserved what he got....

Before even entering the water area he was bouncing off the limiter for easily 10sec, then the official says oi u arent even in the water so he drives straight through the water and gives it another bounce off the limiter just incase he forget where the redline was.

Then he throws it in reverse to backup to the water but realises its 4wd so wouldnt do a burnout anyway so heads towards the line. Stops a full car length short and bounces on the limiter again ready for the green light. Starter official motions him forward and he rolls straight past the line, then reverses back and slowly rolls forward again whilst sitting on the limiter again.

The starter did his usual pissed off start by not waiting until both cars were set (gtr was still rolling) and soon as the 2nd pre-stage light is up he hits the button and the gtr driver decides to let the clutch out. Does a few left to rights and throws on too much opposite lock, front wheels bite and send him sideways towards the opponents wall (whom would have been shitting himself as much as the gtr driver) and takes out his rear end.

No not even 4wd will save dickheads.

:blink:

Edited by benm

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I hadn't thought about the variable power steering assist. Presumably, it will always be the same level of assist as you get in an S14. The R32/3/4 are either helliishly heavy (at low speeds) if the solenoid is not powered at all, or hellishly too light (at high speed) if it is powered all the time. I presume that it is PWM controlled on those cars. I hadn't thought about the S cars not having variable assist. ugh. What crappy plebby cars they must be!  
    • Hmm yeah that is a good point. It looks like it'll just bolt in with no real issue besides maybe the bushings being different. My other concern was that 2 pin plug that I assume is used in some way to control the rack solenoid depending on the speed signal from the ecu. The DMAX rack doesn't even have that plug though so, don't think it'll matter. Might just order the rack and see how it goes. Will update this when I figure something out
    • I'd say it's a fair bet that the feed and return fluid lines will be in different enough spots that you would need to come up with a way to cut the originals short and adapt with new hard line adaption or braided teflon hoses or somesuch. But really, you have the car, you have the photos of the DMAX rack - you should be able to go out there and see for yourself whether they're in the same or different spots.
    • I've been doing some looking around and honestly was just considering throwing a new rack at it. I saw that the dmax silvia rack bolts up into the 33 with the silvia bushings but not sure if the high pressure lines will sit in the correct spot. I believe other version of the 33 rack are the same/similar to the racks that can be opened up without as much fuss so I assume the dmax rack would fit but any ideas?
    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
×
×
  • Create New...