Jump to content
SAU Community

Recommended Posts

saw a couple 4 door 34's today, one on anzac hwy was blue, and had a chick driving. the other was white, had eye lids and some sticker accross the top of the windshield the front end was low and the ass end was way up in the air. had plates RAW 034 or similar

Spotted a Silver S15 with Aus flags on both sides goin up and down the windy point run then he was followed by a 7 or 8 evo. Also a white 88 model soarer which pulled in to BP. Then seen the Silver 15 again pulled in to a servo in blackwood (with a cop car watching them lights off on the side of the road, hope nothing happened)

Meanwhile down south junk food corner police were everywhere. Sitting at maccas and cops pulled/pulling ppl over near HJ's, also opposite Dominos... Then seen 6 patrol and 2 D cars crusing the area

Wasnt too keen so we bailed :rant:

Seen a Orange 33 with kit always parked infront of that shop at semaphore and a white 32 next to it today, Also spotted a TOUGH black r34 GTR infront of Red Rock eating around 8.40. he looks like Vin diesil =D

Spotted my GTR getting reversed into last night.

f**king mole even laughed about the whole thing in my face.

But I'm the one laughing since she didn't report the crash and the cops fined her with driving without due care and reversing without due care!

But on the plus side, hello new front bar! I needed a new one, anyway.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...