Jump to content
SAU Community

Recommended Posts

  • Replies 46
  • Created
  • Last Reply

Top Posters In This Topic

Going camping about 5k outta Port Victoria on Yorke Peninsula.Fishing, 4WD'ing ,motor bike riding, Carlton Cold/ BBQ can't wait.Love Easter.

me and a few boys from victor harbor(couple in adelaide) are planning a lil cruse on friday night, heading up 2 adelaide, i was going to post it up a bit closer to friday just so the plans dont change and see if any1 else was keen to join

ps. i have a big ding in the front of my car atmo, ah well

sleeping (well, trying to)

doing some house touchups

easter egg hunt for kiddies, then family bbq on sunday

pretty much just rest and relax seeing Im so stressed these days

ah spewn i feel your pain

doing easter egg hunt and playing Project Torque my new favourite game :P and trying to convince Luke into loading up sof2 so i can smash him (on second thoughts i better let him beat me since i have his turbo :P)

me and a few boys from victor harbor(couple in adelaide) are planning a lil cruse on friday night, heading up 2 adelaide, i was going to post it up a bit closer to friday just so the plans dont change and see if any1 else was keen to join

ps. i have a big ding in the front of my car atmo, ah well

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...