Jump to content
SAU Community

Recommended Posts

Pardon me for my ignorance as i have never owned a turbo car before...

Im thinking about getting a turbo timer for my car, so i was reading up on the purpose of them... the description they had really confused me...

Can someone kindly explain to me th purpose of a turbo timer in simple words and als the advantage of getting one?

Also, if possible, wats a good one to get?

Also, ive got a R33 Series 2, and my turbo only goes from -7 to 2 or 3, why wont it go higher?

Is there something wrong with the turbo?

Link to comment
https://www.sau.com.au/forums/topic/211605-turbo-timers/
Share on other sites

the purpose of the turbo timer is so the car can run for a bit to cool down the turbo if you've been thrashing it, you dont really need 1 you can just sit in your car for couple of minutes but most people are inpatient and prefer leaving it on and walkin away. theres nothing wrong wit your turbo, the standard boost gauge is in mm/hg not psi, so 3 is actually 7, so if it got up to 7 it would be 14 psi then you mite get issues wit your turbo. hope that helps :cool:

Link to comment
https://www.sau.com.au/forums/topic/211605-turbo-timers/#findComment-3740459
Share on other sites

turbo timers are good for people that are normally in a bit of a rush and can't wait those few minutes in their car so it comes in handy sometimes. Automatic ones are good cos they determine how long the timer should run for with consideration for how much and how hard you have been boosting for. Just got to remember when you do get out and walk away from your vehicle cops aren't around cos they illegal. Make sure it's put somewhere that's not clearly visible from outside of the car or even inside the car too. Make sure you get it hooked up properly so when the handbrake is not engaged it doesn't work, i would think ne1 that installs em these days would make sure to do this but you never know.

Link to comment
https://www.sau.com.au/forums/topic/211605-turbo-timers/#findComment-3740499
Share on other sites

the purpose of the turbo timer is so the car can run for a bit to cool down the turbo if you've been thrashing it, you dont really need 1 you can just sit in your car for couple of minutes but most people are inpatient and prefer leaving it on and walkin away. theres nothing wrong wit your turbo, the standard boost gauge is in mm/hg not psi, so 3 is actually 7, so if it got up to 7 it would be 14 psi then you mite get issues wit your turbo. hope that helps :cool:

didn't think it was for the turbo to cool down but oil to run through it to keep it good so it doesn't sieze or something, not sure though...

Link to comment
https://www.sau.com.au/forums/topic/211605-turbo-timers/#findComment-3740503
Share on other sites

didn't think it was for the turbo to cool down but oil to run through it to keep it good so it doesn't sieze or something, not sure though...

You're both correct but its more a heat issue... if the material cools too fast it can warp/shatter/get fractures, and/or sieze a bearing if said bearing hasnt got the lubricant keeping it cool as it changes state...

I have one built into my car alarm. its great... the keyfob has the shutdown override so I can leave the car, lock up and either wait the 90/180 secs for shutdown, or double click the fob to get it to shutdown immediately... if cops pull me over, double click the fob before getting out.... works every time

-D

Link to comment
https://www.sau.com.au/forums/topic/211605-turbo-timers/#findComment-3740519
Share on other sites

I hate TT's i really do, ive had turbo cars for years and never had a turbo failure.. its not hard to do, just drive normally and sedately for the last 5 mins before you arrive at your destination and you'll be fine.

TT's make your car easier to steal, having the ignition wires right behind the device.

Link to comment
https://www.sau.com.au/forums/topic/211605-turbo-timers/#findComment-3741130
Share on other sites

It says in the owners manual if you've just been city driving to switch off straight away so I suppose 5 mins of sedate driving is exactly the same. If you're driving for 5mins off the turbo then it gives it plenty of time to cool down.

Link to comment
https://www.sau.com.au/forums/topic/211605-turbo-timers/#findComment-3741222
Share on other sites

I hate TT's i really do, ive had turbo cars for years and never had a turbo failure.. its not hard to do, just drive normally and sedately for the last 5 mins before you arrive at your destination and you'll be fine.

TT's make your car easier to steal, having the ignition wires right behind the device.

+1

i agree with simon, there is no need for a turbo timer. not only are they an easy defect item for police, but also makes it easier for thieves to start your car.

drive off boost for the last km or two before you reach your destination then you can either turn off or wait 30 seconds. and like madaz has already mentioned in earlier posts by the time you grab your wallet, your sunnies, wind the windows up, detach your deck and take it with you, get the steering wheel lock on...it should be ample time.

this question is directed at Simon and other members who track their cars...after a hard session at mallalah how long do let your cars idle before you turn off??

:)

Edited by R33LIN
Link to comment
https://www.sau.com.au/forums/topic/211605-turbo-timers/#findComment-3741268
Share on other sites

i for one hate idling in the sheds.. drives me f**king mad and gives me a head ache

after a session, we usually idle at the start line for a bit, then get sent into the pits, so on the drive back its no boost and thats the cool down period. by the time i get to the shed its ready to switch off.

only exception to that was the 40 degree day at lala, i gave it a while longer to cool down

Link to comment
https://www.sau.com.au/forums/topic/211605-turbo-timers/#findComment-3741454
Share on other sites

From what I understand Turbo Timers are for cars without engine oilcoolers.

A Turbo Timer allows time for the engine oil to cool down to a reasonable

temperature before turning the engine off. If you don't let the oil cool down

before switching the engine off, the turbo could get coking (dried oil

deposits) which blocks the oilways inside turbo. The result with blocked

oilways is less oil reaching the bearings inside turbo and eventually turbo

failure.

The harder, longer you push your car, the higher the oiltemps hence why

more idle time is needed to bring down the oil temps.

If you push your car hard all the time, buy a engine oilcooler with thermostat

sandwich plate and oil temp gauge to monitor oil temps.

Link to comment
https://www.sau.com.au/forums/topic/211605-turbo-timers/#findComment-3742264
Share on other sites

i dont mind turbo timmers for one i use a Greddy Fully Automatic turbo timer and it has a lot more inbuilt function for eg... digital speed, battery voltage, and a whole heap other things....i got it all properly installed and its hidden in a safe spot which cannot be accessed easily....during summer or hot days i have it preset to 60 seconds and during winter down to 40 odd seconds.....but as other guys have said that you dont really need a turbo timmer i normally sit in the car till the timmer runs out and then lockup and leave....

Link to comment
https://www.sau.com.au/forums/topic/211605-turbo-timers/#findComment-3743175
Share on other sites

i personally don't use one any more most times you only need 30sec cool down by the time you get your wallet of of the centre console wind some windows up check you've got everything there over 30 secs to turbo timed

geez, how old is your skyline dude. doesn't take long to push a button for electric windows to go up and you can get that added to your alarm aswell if it's able to.

I hate TT's i really do, ive had turbo cars for years and never had a turbo failure.. its not hard to do, just drive normally and sedately for the last 5 mins before you arrive at your destination and you'll be fine.

TT's make your car easier to steal, having the ignition wires right behind the device.

thanks dude, how many car thieves you reckon have a look at forums these days to check out ppls rides. did you wana make it any more obvious? :P

Link to comment
https://www.sau.com.au/forums/topic/211605-turbo-timers/#findComment-3743809
Share on other sites

well thats why you hide the turbo timmer.....even i cant get to my turbo timmer easily....but i do have a kill swtich to shut the timmer off just incase my friends in blue decide to pull me over...

Link to comment
https://www.sau.com.au/forums/topic/211605-turbo-timers/#findComment-3743826
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm seeing torque specs all over the place for the OUTER tie rod, but none for the INNER tie rod, where it connects to the steering rack. Even in videos, people are just tightening em up as much as they can with a wrench and that's it. Anything tightened down without torque makes me nervous. Anyone know what the spec is for it?
    • Hope you had a great time here in our tiny country.   The JDM scene we have here is quite small, it's mostly BMW, Volkswagen with burble tunes haha. But the few JDM cars we do have in the scene are pretty nice. Some of my friends drive cool s14's too. Both built engines, red one makes abt 500, blue one abt 400 i think?
    • Ye good idea , would have never thought of something like that. Might aswell do it to every pulley and the balancer while I’m there 
    • Use an LS1 or similar, via kit like Frenchy's. But.... It's probably not the alternator. It sounds like belt squeal, which would be because the pulleys are glazed. Rub every groove on the pulleys with 120 grit paper. Report back. Oh, and new belts afterwards too. The old new ones will be shitted up already.
    • Hello all I have 2 r34 sedans , one turbo one na, only recently aquired the na 34.  Man what is with these things.... My turbo 34 started sounding like a super charger, it was screaming at anything above 4000rpm , I took the alternator apart and replaced the front bearing which is the only one I think you can access and it did not fix the issue so presumably the bearing in the rear of the alternator is gone. ( diagnosed it was the alternator by taking off the aux belts one by one to figure out which pulley or bearing it was )  My friend gave me one he had lying around, Installed it , it did not squeal for maybe 500kms and now its started to squeal again briefly on startup  Recently got an na r34 and I replaced the timing belt, water pump + all the auxillirary belts. Runs amazing but it suddenly developed the same squeaking problem but significantly worse, Ive had my neighbour come down screaming at me because it was waking her up everytime I moved the car. It takes a good 2 minutes before it quietens down.  Im yet to diagnose where its coming from but im fairly sure its coming from the alternator aswell. My question isnt about how to fix it but rather where can you get a new alternator for an rb25 neo??? Ive searched everywhere but I havent been able to find a direct fit oem type replacement thats not genuine. All the automotive stores sell an oex one - BXA035 - which I picked up for cheap through a friend with staff discount , got it home only to find the connector is completelty different.... As far as im aware bxa035 is for rb20/30's and after a bit of figuring out the bxa035 has an ev14 type connector, which is tiny compared to the rb25 connector. I actually had an ev14 connector lying around which I was considering just replacing the bigger plug with to get the alternator working but the bxa035 is rated for 70amp vs the rb25 alternators are 90amp ( or so ive been told ? ) That paired along with the fact im about to install an amp + sub in the back and I have the stock sized small battery Im not sure itll do the job unless anyone has another opinion?  I know and have seen all the websites selling the ls1 alternator conversion kit but I am not going down that route, nor do I have the money to. Hopefully I can figure out how to get 2 brand new alternators for both cars. I would buy second hand which there seems to be many of but considering how common this seems to be im sure If I installed a second hand one it would start squealing in no time  Or even better if anyone knows how to fix the issue directly with the alternator itself... Any input appreciated Thank you     Link for bxa035 connector picture
×
×
  • Create New...