Jump to content
SAU Community

Recommended Posts

I just don't understand why people keep complaining about getting pulled over for nothing.

I've had over 15 cars with 90% of them turbos.

3 of them skylines.

a 200sx.

2 Liberty RS Turbo's with exhaust louder than most skylines can ever muster up.

Never ONCE have I been pulled over for anything other than RBT.

NSW or QLD.

Never.

they don't do it for no reason.

I have been pulled into a road side breath test and the car had a going over. I was let off as i was actually sober for a change :w00t: . I'm actually more worried about them than the random pull over these days as the car is fairly quiet and doesn't draw a lot of attention (unless doing tight turns in a carpark) but is still easily defectable if someone has half an idea.

  • Replies 69
  • Created
  • Last Reply

Top Posters In This Topic

Maybe that's why your not complaining? I don't complain about starvation cause I eat a lot...

see the very simple point I'm trying to make here?

It was in reference to people saying they get pulled over for doing nothing.

It's never nothing.

it's never because you have a skyline.

it's always going to be for something.

example.

ride height.

general rule being that it can't be lower than 100mm at lowest point.

but that rule is with occupants in all seats and car fueled.

4 people and full of fuel.

I just don't believe people when they say they were pulled over and hassled and defected for nufink!

I got done on Monday, I was heading to a mates place around 2pm, doing 100 on the freeway (limit was 110, I am still on Green Ps)... He would have had a few reasons to pull me over, the back plate had fallen off, but through our discussion, and how he only checked for the front plate after looking at my license, I don't think he knew I was a P plater... That being the case, I would have appeared to be doing under the speed limit...

Other then that, defected for the defectable items on my car...

That's enough reason in my eyes...

But I have still been pulled over 3 times since December, twice, nothing happened...

The subs are in the garage and the amp is broken... undergoing some re-wiring right now...

soooooo no...

PS: My alarm in the morning is set to bro level, I'm way past that now :ermm:

It was in reference to people saying they get pulled over for doing nothing.

It's never nothing.

it's never because you have a skyline.

it's always going to be for something.

example.

ride height.

general rule being that it can't be lower than 100mm at lowest point.

but that rule is with occupants in all seats and car fueled.

4 people and full of fuel.

I just don't believe people when they say they were pulled over and hassled and defected for nufink!

i have been pulled over many times for no reason at all simply because i drive a skyline and because they see it has a type of hoon car so dont go saying that we must be doin sumthing wrong becsause that is not always the case.my skyline looks dead standard and they still pull me over. The police do not have to have a reason to pull u over as ive found out off my bro. if a car looks sus or anything like that they will pull u over

well if your car looks sus (or probably it is you in the car who looks sus), then there is the reason to pull you over.

wot me driving home by myself on a freeway in my stock looking skyline at at 7.30 pm in my work clothes is sus???? mind you not speeding, keeping in the left lane and my car isnt loud at all. pretty f**ked up how i was the only person he deciced to pull over aye! especialy wen all the other cars around wer commodores and camrys

if you honestly think that we get pulled over for doing sumthing wrong all the time then you got no idea. they will pull u over just coz u drive a "hoon" type car

records are made to be broken :)

But I think these are different kinds of records :banana:

and oh yeah, I got pulled over again on Friday :banana: heading home, 1am, still in a suit from work...

were those commodores and camry's modified like your car? probably not hey!

anyway.. records on the computer can last a life time. not just 2 months.

incase u didnt read my previous post my car looks dead stock from the outside, no large canon muffler or anything like that, if u looked at it u would think it was stock

and as i stated before, i was informed by my bro who is a cop that they are normally kept on there for 2 months and if the car has major problems then it will be kept on there for as long as they want

incase u didnt read my previous post my car looks dead stock from the outside, no large canon muffler or anything like that, if u looked at it u would think it was stock

and as i stated before, i was informed by my bro who is a cop that they are normally kept on there for 2 months and if the car has major problems then it will be kept on there for as long as they want

so to answer my question those commodores and camry's weren't modified the same as your car were they? it doesn't matter if your car has a cannon or not. modified is modified.

your 'bro' doesnt know much then does he. if a record is made on computer then its kept on there for a life times.

word from my best mate, is the same as [200]

its there for life, it comes up as an "event" which stays on computer system/file

such as

1. victim of assault

2. traffic infringement

3. defect

4. etc

I have never been harassed in the 32 nor the GTR which has big white stripes down the side.

They will only pull you over if you are doing something wrong.

Stick to the rules and you will be fine.

Skylines need more middle eastern appearenced owners.

then they would "ALL" be stopped and checked, and I would feel less discriminated against for not getting hassled.

should I wear a cap? a white one? and have it backwards or something?

should I leave facial hair in strange designs?

Can those of you lucky people who get pulled over all the time give me some clues as to what I should do to be with the "IN" crowd?

Skylines need more middle eastern appearenced owners.

then they would "ALL" be stopped and checked, and I would feel less discriminated against for not getting hassled.

should I wear a cap? a white one? and have it backwards or something?

should I leave facial hair in strange designs?

Can those of you lucky people who get pulled over all the time give me some clues as to what I should do to be with the "IN" crowd?

get a hektik haircut and perm the long bit at the back?

i got harrassed once

couldn't believe it, I was doing nothing wrong.... all i was doing was going 90 in a 60 zone on bald semi slicks in a low car, with modifications

I swear i was doing nothing wrong.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I guess one thing that might be wrong is the manifold pressure.  It is a constant -5.9 and never moves even under 100% throttle and load.  I would expect it to atleast go to 0 correct?  It's doing this with the OEM MAP as well as the ECU vacuum sensor. When trying to tune the base map under load the crosshairs only climb vertically with RPM, but always in the -5.9 column.
    • AHHHH gotchaa, I'll do that once I am home again. I tried doing the harness with the multimeter but it seems the car needed a jump, there was no power when it was in the "ON" position. Not sure if I should use car battery jump starter or if its because the stuff that has been disconnect the car just does send power.
    • As far as I can tell I have everything properly set in the Haltech software for engine size, injector data, all sensors seem to be reporting proper numbers.  If I change any injector details it doesnt run right.    Changing the base map is having the biggest change in response, im not sure how people are saying it doesnt really matter.  I'm guessing under normal conditions the ECU is able to self adjust and keep everything smooth.   Right now my best performance is happening by lowering the base map just enough to where the ECU us doing short term cut of about 45% to reach the target Lambda of 14.7.  That way when I start putting load on it still has high enough fuel map to not be so lean.  After 2500 rpm I raised the base map to what would be really rich at no load, but still helps with the lean spots on load.  I figure I don't have much reason to be above 2500rpm with no load.  When watching other videos it seems their target is reached much faster than mine.  Mine takes forever to adjust and reach the target. My next few days will be spent making sure timing is good, it was running fine before doing the ECU and DBW swap, but want to verify.  I'll also probably swap in the new injectors I bought as well as a walbro 255 pump.  
    • It would be different if the sealant hadn't started to peel up with gaps in the glue about ~6cm and bigger in some areas. I would much prefer not having to do the work take them off the car . However, the filler the owner put in the roof rack mount cavities has shrunk and begun to crack on the rail delete panels. I cant trust that to hold off moisture ingress especially where I live. Not only that but I have faded paint on as well as on either side of these panels, so they would need to come off to give the roofline a proper respray. My goal is to get in there and put a healthy amount of epoxy instead of panel filler/bog and potentially skin with carbon fiber. I have 2 spare rolls from an old motorcycle fairing project from a few years back and I think it'd be a nice touch on a black stag.  I've seen some threads where people replace their roof rack delete with a welded in sheet metal part. But has anyone re-worked the roof rails themselves? It seems like there is a lot of volume there to add in some threads and maybe a keyway for a quick(er) release roof rack system. Not afraid to mill something out if I have to. It would be cool to have a cross bar only setup. That way I can keep the sleek roofline that would accept a couple bolts to gain back that extra utility  3D print some snazzy covers to hide the threaded section to be thorough and keep things covered when not using the rack. 
    • Probably not. A workshop grade scantool is my go to for proper Consult interrogation. Any workshop grade tool should do it. Just go to a workshop.
×
×
  • Create New...