Jump to content
SAU Community

At Wat Power Level Do U Start Running Into Problems With The Standard Rb26 Fuel Rail


Recommended Posts

i had my car on the dyno for a tune yesterday and when we got to 400kw it started running into problems with fuel

we had a fuel pressure + flow gauge connect to the car while we were tuning the flow doesnt drop at all but the fuel pressure goes from 40psi to 60psi and then just drops back down to 40 instead of going higher it just drops back to 40 and the car leans out so we neva got to finish the tuning

fuel system is pretty basic

bosch 023 (rated at 700hp) mounted intake

SARD 800cc injectors

HKS fuel reg

well pressure dropping is usually an indictor of pump running out of puff, or faulty fuel regulator, not restrictive fuel rail. are you sure the fuel flow wasn't affected at all by pressure change? where were you measuring the flow, and how?

dirty fuel filter?

its got a brand new fuel filter already on it

well pressure dropping is usually an indictor of pump running out of puff, or faulty fuel regulator, not restrictive fuel rail. are you sure the fuel flow wasn't affected at all by pressure change? where were you measuring the flow, and how?

it cant be a fuel reg because at 1st we thought it was a faulty fuel reg and replaced my SARD fuel reg with a HKS one and it changed nothing

the fuel gauge we have is the blue one

the gauge is used to measure fuel pressure the it has a ball which moves up and down to show u how much fuel flow u have

isnt the 023 rated less then a 044?

could be upgrade time

the 044 is rated at 600hp

the 023 is rated at 700hp

if you are running stock wiring to your fuel pump then that will be part of your issue kemp

we have already wired the fuel pump so it gets full voltage

are you sure the 023 is rated higher than a 044? From what info i could find the 023 is rated at 163L/H @ 5bar vs. the 044 rated at 200L/H @ 5bar.

The HP ratings on pumps vary by 300hp depending on where you buy them, the L/H don't.

Who has actually found the limits of the stock fuel rail?

I know its not the answer to your question but i had just on 400 KW at the treads on a stock rail and Nismo regulator.

I know its not the answer to your question but i had just on 400 KW at the treads on a stock rail and Nismo regulator.

Cool thanks

Would be good to know at what point it gives up for future reference and anyone doing a search will no doubt read this thread and hope to find the answer

at 400 rwkws i would be starting to think about 2 044 to give you some room to play.

as i mentioned earlier 1 x 023 would be simply running out of legs.

Why?

I run a surge/external in mine and i drive it daily. I cant say its that much louder at all if the pump is mounted decently

i realli dont want to go threw all the trouble of fitting a surge tank and all the lines im after some thing i can just bolt in and fit the problem

i wanna get out of this the most cheapest way i can as well

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I have had too many of those over the years, my cars have a toolkit or at minimum a cheapy multi tool thing because its too easy to be snookered by some stupid plastic clip that stops you checking the battery terminal isn't loose.
    • Basically, if there is a part# on the nissan catalogue, it is a genuine part. There is a thing called "new old stock" which is stuff made years ago but never sold (or landfilled), but it is super hit and miss what you can buy. Other than some expensive Nismo stuff there is nothing new being made that suits these cars. The only time to be a little careful is (mostly in the US I think, but maybe Japan too), Nissan started rebranding some cheap crap maintenance parts like oil filters as "Pitworks"; stay away from them, if you are buying cheap just buy whatever the local car parts shop carries The three part numbers have an explanation on Amayama: 0V005 is auto, base style 0V015 is manual 0V505 is auto, hectic momo branded ones, maximum F&F points there!
    • Just to get this straight if you turn the splined shaft to the outside, it turns freely but the chain does not move? What happens when you move the chain, does the splined shaft turn? Surely the shaft is snapped, or the chain is seized and it took the teeth off whatever great is behind the steel bracket
    • Good on you for mentioning, that helps as far as other things you might need to check
×
×
  • Create New...