Jump to content
SAU Community

Recommended Posts

Guys, I need your advices, I have a R33 gts-t, I found it's quite scary to drive in the wet sometimes, the car starts to "Drift" when I take off in first gear to make a turn, sometimes in a hurry right turn, I feel i'm going to lose control and spin around.

have u guys experienced the same problem??? My car only has some basic mods, FMIC, turboback exhaust, CAI, standard turbo, and most of the time I run stock boost, so there is not a lot of power. I have Buddyclub N+ coilover suspension and the R34 Gtr wheels fitted, tyres are Dunlop lemans, few months old. In a sunny day, it's fine, only happens in wet.

Yeah !! I have the same issues, on wet roads, I think it's due to hard suspension. I got EDFC setup in my car and I noticed that harder the suspension I set, less grip on wet roads I get. So I always drive on softest setting on wet and just have to be very careful. I try to drive without the turbo kicking in (slow launch)

Yeah !! I have the same issues, on wet roads, I think it's due to hard suspension. I got EDFC setup in my car and I noticed that harder the suspension I set, less grip on wet roads I get. So I always drive on softest setting on wet and just have to be very careful. I try to drive without the turbo kicking in (slow launch)

Which Tein have you got??? Super street??? I set my Buddyclub N+ to softest, and it's still happened

what tyres are you running? hows the wear on them? how low is your rears, how much camber does it have? When i put my tiens on they lowered the car and gave me a fair amount of camber front and rear. the extra camber on the rear created uneven tyrewear on the inside of my tires and I could easily break traction when turning in first say to do a U or 3 point turn. It got to the point where it was quite predictable. Would also break traction in the rain on red lights if i gave it say 1.5k revs on take off.

I now have a set of good Yokos and camber kits so it doesnt do it anymore.

what tyres are you running? hows the wear on them? how low is your rears, how much camber does it have? When i put my tiens on they lowered the car and gave me a fair amount of camber front and rear. the extra camber on the rear created uneven tyrewear on the inside of my tires and I could easily break traction when turning in first say to do a U or 3 point turn. It got to the point where it was quite predictable. Would also break traction in the rain on red lights if i gave it say 1.5k revs on take off.

I now have a set of good Yokos and camber kits so it doesnt do it anymore.

Thanks for your reply, very helpful info.

Tyres are Dunlop lemans, about 3000kms old. rear is about 340mm center of wheel to guard. I don't have the camber kits, so I guess I need the camber kits to fix the problem.

I found it's quite scary to drive in the wet sometimes, the car starts to "Drift" when I take off in first gear to make a turn, sometimes in a hurry right turn

Don't hurry then. Slow and deliberate.

R34 Gtr wheels fitted, tyres are Dunlop lemans, few months old. In a sunny day, it's fine, only happens in wet.

Everyone else has covered most of it on the tyre side, so my only other suggestion is to set the suspension up to understeer as much as possible. If it rains set the rear dampers to full soft and the fronts to full hard. If the ride's a bit too harsh in the front dial it back little by little, but always ensure the fronts are a lot stiffer than the rear.

Which Tein have you got??? Super street??? I set my Buddyclub N+ to softest, and it's still happened

I'm not sure what Tein they are , coz I got them with the import, didn't bother to chech back then and didn't have much knowledge either.

It is called drving normally. It requires throttle modulation rather then just floorg it :yes:

I agree with Roy, even a stock skyline would lose traction on wet conditions. The mods make it worse (but perfect for dry conditions). So I guess there’s nothing we can do about driving when wet other than just been very careful and always keep in mind that your car is designed and moded to suit dry conditions.

Just go easy on the gas when wet.. nothing wrong with the car… J

It is called drving normally. It requires throttle modulation rather then just floorg it :P

I drive very slow on road, most of the time with the boost controller is switched off, but it still loses traction in first gear in the rain

short shift into 2nd as soon as you get rolling

fix the camber in the rear that's the main thing (I also suspect your suspension is too hard)

dunno what else to tell you, mine just grips in the wet, the rears only spin if I want them to... and that's with 260rwkw and 2way mech diff... some pineapples set to squat might help as well

when I first got the car I had hard springs in with worn standard shocks and crappy federal tyres and the thing was pretty lethal in the wet... totally different car nowadays

It is called drving normally. It requires throttle modulation rather then just floorg it :D

ZING

i can break traction in 3rd in the excel when its wet......

its all about the right foot

+1 on throttle control.

My car is stock power wise on 255 Federal 595SSs, and in the wet it is very easy to get the rears spinning, even on fresh tyres. I manage to keep traction though by keeping the revs below 2,500 rpm (even taking off from lights in 2nd) and taking it easy around corners.

It is all about driving to the conditions.

If you really can't do this, get a piece of plastic and block about 3/4 of your air filter. The resulting restriction should bring the power down so you will get no wheel spin at all :spank:

I don't have issues with traction in the wet with a fair amount of throttle, too much throttle and you lose it but I do have AWD...

How *much* power are you putting down? With how much accelerator?

You could have badly setup suspension OR bad tyres, or you could just be overestimating your car, most cars with a good LSD get sideways in the wet with heavy acceleration, but it's hard to tell on a forum what exactly is going on.

There are some serious topics on getting power down somewhere here (as in suspension, not about right-foot control :spank:)

EDIT: Oh, on corners, it could be suspension setup or it could be overestimation of the car's handling. What rating are the springs of your suspension?

And Dunlop LeMans are *ok* in the wet, not the best, I have them as well, the fact that you have 18inch rims on a GTST also means much lower profile so that's probably not going to help.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Block bump. $400. As above cyl 6 needs bore or sleeve.
    • I would think making the argument that the travel is limited by a spring flexing against a spring perch as "the same method". Later on in the document they do state that the spring can't bind on full bump travel and cannot come loose in full rebound travel as well. (which is all very sensible). The laws are actually pretty sensible and reasonable. It's just that the people who enforce and check them don't actually read them or know them accurately. "Oh, coilovers? Instant fail mate. Don't even need to look at it." - Guy who will be instantly reported by me. There is probably merit to people who do get defected for height also get defected for the suspension in that state that allows it. I did never consider the people who are complaining about coilovers being picked on are also running around at 50mm off the floor.
    • I think given SAU's knowledge of E85 we can strongly conclude that 10% ethanol in almost any situation is entirely fine. Almost all of the myths against E85 were overblown, let alone E10.
    • From your link See bold text, is this referring to damper settings, if so that may a issue for "some" inspectors, I cannot see aftermarket coilovers having the evidence that "must be available that its functional performance is equivalent to the original" Maybe just remove the adjustment knows and hope for the best???? Meh 5.2 Suspension travel In all instances, modifications to a vehicle’s suspension must ensure the integrity of the system and not compromise the ride quality. At least two thirds of the original suspension travel should be maintained in both directions (rebound (i.e. extension) and bump (i.e. compression)), and rebound must be limited by the same method used by the vehicle manufacturer or if this is not practicable due to the nature of the modification, an equivalent method. If an alternative method is used, evidence must be available that its functional performance is equivalent to the original.
    • They actually don't - They adhere to VSB14 rules just like Victoria. The rules are against CABIN adjustable height, and it quite clearly states that the height has to be within parameters. I asked the VASS engineer to confirm this when I got my car engineered and they refused to engineer the coilovers because they didn't meet the requirements for requiring engineering. (mine are height adjustable.) People "Not wanting to bother" with "Actually reading/knowing/adhering to the rules" should result in fines and immediately losing the ability to issue blue slips and/or RWC's in Vic.
×
×
  • Create New...