Jump to content
SAU Community

In Car Circuit Videos

djr81
 Share

Recommended Posts

  • Replies 796
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

XKLABA
XKLABA

Me at the Bathurst Esses hill climb the weekend just gone With a time of 28.28 giving me the class win and 0.17 off the class record on my first time up there

SILKGOD
SILKGOD

Phillip Island 16-06-2013 After a wet start in the morning the day got better. Still very cold, had a lot of trouble getting heat into the tyres. Couple of issues spun the rear yoke in the tail shaft

Posted Images

Jetwreck Grand Master

Jetwreck

Posted
Posted (edited)

Bit of DR30 love......plus Dad putting it around in front of me at PI followed by the Winfield car going past towards the end.....sucked having the wrong diff(4.11), a electrical problem and only 1.1bar of boost.

Edited by Jetwreck
boxheadmr Mentor

boxheadmr

Posted
Posted

Hi,

Some footage of me from PI in Feb that i have finally gotten around to putting together,

Fist lap was my fastest in this session with a 1.48 just as it started raining. This is from a Go-Pro hero HD and with the in cabin video sound put over it as the Go-Pro sound was no good.

Got a little sideways through Turn 1 which was fun.... this is what happens when you are too busy looking at your speedo rather then the turning point.

Guy in a commadore nearly cleans me up

  • 3 weeks later...
benm Grand Master

benm

Posted
Posted

Here are my first video's of my little Nascup car taken at Wakefield 2 weeks ago. They aren't the best quality as I didn't realise how much vibration their is in my fiberglass shell so the camera couldn't focus very well.

1:18sec (old pb)

1:16sec

1:14sec (pb)

That's my second event of just turning up and driving without changing the car setup so im happy with it for now. Want to replace the 20yo FJ1200 100hp with a 5yo Hayabusa 180hp before the next SAU trackday.

Jetwreck Grand Master

Jetwreck

Posted
Posted (edited)
Sweet sounding car. Any more pics and specs of it.

Spec's: lot's of RB20 love!!!

It's the car in the pic with the most grip at the time but also the most out of place....hint....headlights are on!!!

post-37023-1274089381_thumb.jpg

Edited by Jetwreck
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • djr81
      RB26DETT Sketchy boost mod?

      By djr81 · Posted

      Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
    • PranK
      Chris' Toyota Mark ii JZX110

      By PranK · Posted

      This looks great! Awesome to have the 5 speed with an LSD in this. The Recaro's look like SR2's or SR3's. It's a shame they've been retrimmed as they would have looked sweet in their original colours. I think I'd want my agent to be a little more up front and informative too. I've never imported but I reckon it would make me a little nervous, so the more info the better.
×
×
  • Create New...