Jump to content
SAU Community

Recommended Posts

so you guys definite on meeting there , i posted a meet at hungry jacks in warwick farm but if casula oportos is better we can meet there

i can update that post then so meetup is changed to oportos casula is everyone is definite

There is plenty of room here for 30+ cars, I'll be there +1 passenger...

Also sounds like the lunch thing is already booked, prob gonna grab something else if its fully booked...

anyone know any other places round there we can eat and meet up?

  • Replies 328
  • Created
  • Last Reply

Top Posters In This Topic

what time do you guys plan to leave if we meet at 9:30?

Depends if we use the m7 (get off sunnyholt rd and head up windsor rd)... if so it'll prob take about 30-40min

So i'm guessing we wont be leavin much after 9.30

just my 2c

you suck eric!

please no more deposits for lunch after 6pm tomorrow, we will not receive the payment in time so we can't book for you.

of course everyone is still welcome to cruise, it will be a great day (one of the biggest cruises I've seen in years!)

There is plenty of room here for 30+ cars, I'll be there +1 passenger...

Also sounds like the lunch thing is already booked, prob gonna grab something else if its fully booked...

anyone know any other places round there we can eat and meet up?

cya's there

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...