Jump to content
SAU Community

Recommended Posts

spotted MSP-25T :D

moans, i horned but u didnt look... u must of had ur music up loud or something ;)

this was tonight around 7.50pm at the end of james ruse dr.. u were turning right to go towards granville and i was turning left

GET OUT!!! you were on james ruse turning onto parra rd?! i missseeeddd youuuu!!!!!!!!! :D i did spot a 33 just a lil down parra rd about 2secs later!!! can't believe i missed you ;)

NNNNNNNNNNNNNNNNNOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOO /darth vader

Hi, I think that was me : )  , were u in a series 1 right ? Good to know u acknowledged  coz i waved to mostly non-wavers recently ^^

Tell me about it... It's turned me into a non waiving bastard! :)

But yeah, was definately me. You live anywhere near that area??

Burnsey

spotted sexy 321 GO on penno rd this evening :D hehe.. sorry for the fly by!! i was in such a rush to catch up, i couldn't stop by the time i got to you! lol!!! and all the beeping was cause i thought you were going straight! i'll be more subtle next time! lol!!! good to see you and the car though! :)

spotted ONISMO silver r33 gtr at macquarie uni, see it all the time, nice car but has had a bit of damage to it, not bad though...

hey i see that GTR all the time! do you spot my black r33 with VS front kit and GT wing? i usually park in the open carpark behind the bus stop, what colour is ur 33?

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...