Jump to content
SAU Community

Recommended Posts

Silver 33GTR with CL ### plates... headed down Mt Ouzley into Wollongong very sedately, stuck behind a slow truck, I gave you some room but you decided to wait...

one very clean ride!

I've also seen a yellow 33 and a black 33 GTR (i think) coming down there too

And a Black 33GTST stopped next to me at the lights in Wollongong near Masters Rd, chick driver, older guy in the passenger seat.

I didnt think to catch the plates.

Edited by B. J.

Spotted a Maroon 33 GTR with huge "Buddy Club" stickers all over it

Also spotted a grey 33 GTST boosting past Chatswood station..series one i think.

Also spotted an S15 with the "Ikeya Sequential" H pattern convertor thing. Man that thing looks chunky....i like it

Spotted a silver and two black R33's (all GTSt's) and a silver R34 GTt sedan heading down the F3, Pennant Hills Rd and the M2 on their way to Friday night drags at EC.

All Central Coast and Newcastle people, apparently...

Spotted Primordial on Monday just leaving just jap!!!

;)

o o o and B-mans Cosmo outside Hitman on Monday night! Looks good! Man those brakes, they are MASSIVE!

Hey! What car were you in? I remember seeing an S15 going the other way when I came out..?

Spotted a silver and two black R33's (all GTSt's) and a silver R34 GTt sedan heading down the F3, Pennant Hills Rd and the M2 on their way to Friday night drags at EC.

All Central Coast and Newcastle people, apparently...

Hey,

I was the R34 GT-T Sedan - I actually live in epping but I work on the coast so hang with them mostly.

Thought it was Goldzilla car but on the two ways the others were thinking of someone else, till that talked to ya.

Drew.

Hey! What car were you in? I remember seeing an S15 going the other way when I came out..?

I was in the car behind the s15..... which was the Proton :( lol

I must have missed you by less than 3 mins!!

Hey,

I was the R34 GT-T Sedan - I actually live in epping but I work on the coast so hang with them mostly.

Thought it was Goldzilla car but on the two ways the others were thinking of someone else, till that talked to ya.

Drew.

Hahaha, hey Drew. I was driving, and my cousin (his username is "blukie") was talking on the UHF CB's. Didn't get to chat for long because the batteries went dead on the CB - I think I've had the same batteries in there since I bought the thing years ago (it must be at least 4 years)...

Who was it that said my car was the "green Camry-looking thing..." over the CB's? :(

Even worse is that someone didn't know what a Stagea was - there are a few up Newcastle way, and they are on the forums too! :ninja:

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...