Jump to content
SAU Community

Recommended Posts

Spotted white R34 coupe ESH-11S on Epping Road this morning

Ha ha ha, you spotted the coupe but if you spotted me like i think you did cause you wave you didnt post it!

Spotted wink this morning around 8:40am along beecroft rd

Ha ha ha, you spotted the coupe but if you spotted me like i think you did cause you wave you didnt post it!

Spotted wink this morning around 8:40am along beecroft rd

Did I wave? I can't remember! Usually when I drive to work in the morning I am in a total daze! :(

HAHAHAHA so that WAS you !!!!!

I only met you once so I wasnt sure if it was your or not !!!

Was that you, Thomas?

Didn't recognise you either, because I only got a proper chance to look at you in the rear-view mirror, and I figured it would be a better idea to keep an eye on the road - especially through those curvy bits leading up to Ermington...

Heard a small chirp as you left the lights in front of me just before you turned onto Silverwater Rd. Button clutch?

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...