Jump to content
SAU Community

Recommended Posts

spotted HICAS I think in the Ryde area heading toward chatswood in peak hour traffic on Friday if I remember correctly.

Car looked nice :P

ZOMG I was spotted while not cruising with 11ty billion other Skylines :)

You where obviously travelling in the other direction as my car is still mangled on the passenger side of my front bar... should go about painting my other one soon :)

Spotted a white 34 gtt with blue plates + P plates in russell lea/drummoyne near lyons rd.

That was me!!! :( its not a gtt - just a GT ;) - but yea thats cool you spotted me because i was just doing a delivery for a mate - i dont live anywhere near that area - im a hills boy :(

Spotted a silver R33 GT-R tonight at around 5.30pm heading up Delhi Rd, North Ryde, following a sports bike up the inside lane.

I *think* the rego was GTR-033, not sure.

just spotted a silver 32 four door, black boot, p plater... Of course being a f**king toolbag in traffic, just then in artarmon

That would be me i had a baaad day and just wanted out

That was me!!! :bunny: its not a gtt - just a GT :bunny: - but yea thats cool you spotted me because i was just doing a delivery for a mate - i dont live anywhere near that area - im a hills boy :bunny:

Haha its hard to tell gtt or gt. I was in the black 81 ke55 corolla (GO55GO) in front of you when we both turned right. 32 is off the road getting an engine swap.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Update: tested my spark plugs that are supposed to be 5ohms with a 10% deviation and one gave me a 0 ohms reading and the rest were 3.9ohm<, so one bad and the others on their way out.
    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
×
×
  • Create New...