Jump to content
SAU Community

Recommended Posts

hey! yeah thats me, just bought it. thanks!

i cruised down windsor rd one morning last week with a hot black r32 gtr, n1 lip, BBS rims.

i gotta come for a cruise, whats this hills cruise business? :)

eheh, that was me mate. Then I met you at the Pizza Cruise - should have stuck around to the end, it wasn't much further than where you turned off. Not sure what the hills cruises are, but if you figure it out let me know coz im in Beaumont hills.

Oh yeah spotted around 20 skylines, 2 stags, a lotus and 2 bikes on the Pizza cruise!

a white r32,r33,or r34 (not sure which one from distance through trees), tearing it up the hill from berowra waters ferry this arvo @ 5pm

spotted a yellow r33, gts-t maybe, had a trial rear bar

was heading onto the bangor bypass after the wonnie bridge

was around 8.45

didn't get to catch up coz i had to take the turn off through bangor

that was me dude.. on my way to the gym. its a gtst with a veilside rear bar.

i spotted a grey or black r33 gtst and a white r34 gtt that night too.

Spotted a new R35 GTR - Demir leather is the owner ..

Also spotted a white R31 decked with Front mount in manly area, GTR R34 Bayside blue in the same area with some "too good to wave" guy driving it!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...