Jump to content
SAU Community

Recommended Posts

Quite a few skylines down here in the highlands now. Black r34, white r33, silver r33, a grey r32 and i think there is another turbo white r34 slinking around.

Edited by BLKYLO

Quite a few skylines down here in the highlands now. Black r34, white r33, silver r33, a grey r32 and i think there is another turbo white r34 slinking around.

So you are the Yellow 34 I'm always waving to.

I'm in the white R33.

No its not mine. I see it regularly though. I think the dude may work at the panel beaters at the lights. Mine has gold vs xx wheels and a front lip spoiler.

Ahh okay. Gold VS XXs are a nice choice!

Spotted 3 R34's on Saturday night around 9:45 at the lights of Pennant Hills Rd & Carlingford Rd, didn't get the plates but noticed red P plates on the white 34, I was in the white 32 turning onto Carlingford Rd

Spotted a clean white BNR32 - 32.VSPC - parked at Hornsby!! Anyone from here? I live just cpl streets away!!

Hey mate, yeah that's my car. Your 32 looks good to mate but I haven't seen it around Hornsby yet.

Hey mate, yeah that's my car. Your 32 looks good to mate but I haven't seen it around Hornsby yet.

hahaha i was driving behind you the other day when you were driving towards Sherbrook... i turned off at Linda... Followed you from Burdett!

Your V-SpecII looks brilliant!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...