Jump to content
SAU Community

Recommended Posts

Followed A?L-01L (Grey GTS-4) down Norton Street :wavey:  

Oh and I think you need a tune:  when you put your foot on it a huge cloud of black smoke emerged :D

Lucien.

I'm having trouble getting into your link below it wan't accept my my log in???

Can anyone help from Admin of SAU??? Please!

Followed A?L-01L (Grey GTS-4) down Norton Street :wavey:  

Oh and I think you need a tune:  when you put your foot on it a huge cloud of black smoke emerged :)

Lucien.

:wavey: back at ya.

Do you live round the inner west too?

I know i need a tune its running rich as :Oops:

By the way its a 4 door GTSt , not gts4.

thanks

Adam.

:wavey: back at ya.

Do you live round the inner west too?

I know i need a tune its running rich as :Oops:  

By the way its a 4 door GTSt , not gts4.

thanks

Adam.

I live in Leichhardt. Apologies for the failure to correctly identify you: I must have been exhausted from my efforts at gym :)

Lucien

Drunkan,

Yeah, it went ok. #1 turbo is leaking a bit of oil and a bit of water, so we need to re-work #1, the CAMs whistle a little so Im not sure about that. The HKS dumps dont have a spot for the exhaust temp, so its dead and I have an issue with boost and the oil temp. But other then that its fine!

Drunkan,

   Yeah, it went ok. #1 turbo is leaking a bit of oil and a bit of water, so we need to re-work #1, the CAMs whistle a little so Im not sure about that. The HKS dumps dont have a spot for the exhaust temp, so its dead and I have an issue with boost and the oil temp. But other then that its fine!

:ohnoes:

Did you buy the correct HKS extension kit Paul? Sounds like you might have dump pipes meant for a 32 or 33.

spotted GUN-32R Marron R32 at Carrigton Rd, castle hill at the tyre place. had huge, 18 inch volks and 275/35/18's on all 4.

cool that was me, are you ati-something, white r32 gtr with a black rear spoiler?

i saw that at the corner of carrington and victoria today thought maybe you?

I live in Leichhardt.  Apologies for the failure to correctly identify you:  I must have been exhausted from my efforts at gym :D

Lucien

You live in Leichhardt?!?

So do i !!!

I dont think i have ever seen you around before though.

Thanks

Adam

spotted nismo34? tom?

black r34 GTT

apparently lives a few roads down from me but ive never seen him before hahaha

anyways, nice car... black is hot!!

rather poor performance from me too but oh wellz ^^, will get it sorted after exams

cheers

Eric

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Update: tested my spark plugs that are supposed to be 5ohms with a 10% deviation and one gave me a 0 ohms reading and the rest were 3.9ohm<, so one bad and the others on their way out.
    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
×
×
  • Create New...