Jump to content
SAU Community

Recommended Posts

Hay guys.

My stag has recently started to overheat while sitting in traffic or driving with the air con on, i have already replaced the thermostat and put brand new genuine nissan coolant, the radiator is the next step isn't it or is there anything else that i should be checking ? 

Allso are there any specialists that fix radiators or am going to have to get a brand new one ?

Im really over it at the moment, its an expensive time of year and i have just paid rego, the last thing i need is this...

Any help apreciated guys.

Cheers.

Link to comment
https://www.sau.com.au/forums/topic/300527-my-stag-is-overheating/
Share on other sites

  • Replies 43
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

yeh hit me a few xmas's ago.

original radiator went south as I was driving to the tuners for some work, leaked everywhere and was lucky was just around the crnr - so that added $180 to the bill for a 2nd hand R33 core.

6months later the replacement R33 radiator went south after a hard nights work...

so I bit the bullet & went to a NatRad outlet store, paid around $450 installed for a Koyo radiator to suit a R33

since then the temp has never been an issue. always always under half on the factory guage, even on a warm trackday

one of the best repairs / upgrades Ive ever done. not much wider than stock but oh so efficient. definately been proved (by me) to be damned efficient.

1st thing first, flush and check. repair. but eventually a replacement will be the only option- fixes to a broken radiator are only temporary in my opinion,

with the general age of the vehicle id suggest to replace with a new one straight out so its never an issue ever again

but then again if its only getting warm, you could get by a fair while with a flush./

will try get a flush done, the radiator looks immaculate and the car has only done 67 thousand k's, but if the flush dont work ill get the radiator, do i have to go to a specialist to tell me how blocked it is or will my mechanic be able to do the test and tell me ?

I over heated mine last Xmas going up the Toowoomba range so I had the radiator flushed ($400.oo) no real help.

I then had it cleaned by a specialist they took top tank off and inserted a bar down each core then replaced the top tank $170.oo it has been good ever since. :3some:

If I had done this in the first place it would not have cost me an engine rebuild $8,000.oo. :/ I am now looking at putting in an aluminum one as soon as I can afford it just for extra piece of mind.

My opinion at least get it cleaned by a professional it costs a lot less than a rebuild.

Not a Stagea but bought a Sillycar and on the drive home it boiled. Replaced radiator cap with correct pressure type, still boiled. Took it out and had stripped and rodded out. It was 80% blocked.

Interesting though was my RMR30. I always flushed the radiator and filled it with proper coolant. It did 600k and has been in my MR30 for two years. Cleanliness is second only to cleanliness.LOL

Where do you usually take your car, Eddie? I know of a few places out my way (Parramatta and Hills areas), but nothing about who'd be available in or around the city, unless you look at the North Shore options..

car usually gets looked after by tunehouse is maricville, my mate told me last night that he knows a radiator specialist in st peters so ill go see him on the weekend first

mate if it was the radiator it would get hot when driving and under loads like going up hill like mount ousley. Id be looking at your engine fan operation. Ive replaced a few clutch fan assy in R33s, you can buy the clutch assy for around $110.

It wont hurt to get the radiator flushed, but at least test the fan. Can do this by grabbing hold of it. It should spin freely when the engine is cold, but should be very hard to stop when the engine is up to temp.

The reason i think this is your issue is that airflow provides the cooling when you are moving and the fan provides the airflow when you are stationary.

Bezerk, that makes sence mate, i spoke with my brother this morning and he said the same thing, i will test it tomorrow and if thats the case ill get a new clutch fan assy, thanks for your help guys, i really didnt think my radiator was blocked because i flushed it when i changed the thermostat and all the water was clean coming out of it.

it still might not be the case but worth checking.

Bezerk, that makes sence mate, i spoke with my brother this morning and he said the same thing, i will test it tomorrow and if thats the case ill get a new clutch fan assy, thanks for your help guys, i really didnt think my radiator was blocked because i flushed it when i changed the thermostat and all the water was clean coming out of it.

no one dis-agrees, but this requires the removal of the top tank, costs about $88. all i am saying is check the fan first.

Just because the flush liquid is clean doesn't mean the cores are clean and unblocked. You need to run rods down each core to dislodge solid material stuck in there.
I took the rad out and it cost $80 to pull apart and clean. Get a quote.

yup, I was quoted the same by NatRad for me taking it out and no toptank, in the end being in an apartment I needed drive in drive out, and the top tank was extra. cracked on pull apart along the flat bit behind the cap.

The fan can work perfectly, and if the cores are blocked it will still heat up in traffic with the aircon on. Plug something into your consult port and monitor it, the factory gauge is a normal range or OH SHIT.

When they did the flush on mine they ran a chemical in the coolant for 15min to loosen up any debris then connected there machine between the top hose and the top of the tank and forced the coolant through. The coolant that came out looked to be the right color (not dirty or Broun). When I had the radiator cleaned they said that the radiator was about 80% blocked. I also needed a new top tank that is why it cost $170.oo. What you have to consider is that it is only a single row radiator so it doesn’t take much to block it.

Never had a problem with my Stag in the past, but one long trip did see the temp gauge climb ... I went and bought a 52mm alloy radiator anyway. Its now been thru some 40+ degree days without a problem at all. Best investment. :banana:

  • 4 weeks later...

What was the outcome? Don't suppose it could be a problem with the water pump?

My car is experiencing a tiny radiator leak. I'm thinking it might have the wrong radiator cap. The radiator cap I have is a DORTEC PDR11 0.9kg/cm PUSH TYPE RADIATOR CAP, Are these stock ones? I put on cap from an R31 just to try.

I wonder if these radiator issues are caused by some importers putting in crappy coolant?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
    • This looks great! Awesome to have the 5 speed with an LSD in this. The Recaro's look like SR2's or SR3's. It's a shame they've been retrimmed as they would have looked sweet in their original colours. I think I'd want my agent to be a little more up front and informative too. I've never imported but I reckon it would make me a little nervous, so the more info the better.
    • Thanks for doing that Duncan! Makes you a good person in my books. We don't get kangaroos or wombats here. But we have bats and it's similar. AFAIK it's often the mums with a baby attached that get hit because they drop lower when starting from a tree. If you hit an animal, check on it. https://www.ifaw.org/au/resources/wildlife-rescue-app An app to get the closest wildlife rescue contact.
×
×
  • Create New...