Jump to content
SAU Community

Recommended Posts

l8r.... enjoy waking up in 6 hours

ouch.

had a guy offer me 4k. told him nah 5.3 minimum, convinced him its a great price for the condition of the car etc

hes coming tomorrow lunch time to look.

wish me luck fags

the longer your car is for sale the less buyers expect to pay take 4k and move on man fark ive lost over $60k on cars in 6 years suck it up.

I say he will show up and still be persistent on getting his price of $4k regardles of whatever you told him over the phone.

Its human nature to score a bargain and people will always haggle from stated price. No one is going to say "oh I was looking at a car for $4k, but this guy assured me it was worth $5k+ and hence I paid what he wanted"

Expect to be low-balled

this

its 3.5k more than the only serious offer on the table.

high 5!

Its just another tramp who was lucky enough to inherit the good genes..

Relax yourselves and get some standards ffs

Tramp or not, there is no reason not to want to buy her a cheap pearl necklace.

think its against forum rules or some shit

anyway

here we go

clicky

/r/ pics

with the vodka?

tumblr_li4v0iF9em1qe11kdo1_500.jpg

:laugh:

had a trade offer for a VT spac, genuine manual.

:rofl:

sif buy pearl necklace bitches gotta earn em :whistling:

Giggity!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
    • I do have loctite 243 and 246 and a few more models. I could drill it now in place and make new threads for m12 and order an4 - m12 coupling and fit that to the turbo. Run a braided hose to the EBC which I could get a an4 to 1/8npt 
    • So M12 and sealant should be fine?    NPT ” because that’s what I had and what I could get atm. 
    • Wouldn’t touch par if they gave it to me. You need to ask how much power you’re looking to make and then add about 50% to it because that’s what you’ll end up making  The factory box says no more at about 350kw or so, the upgraded synchro boxes won’t handle much over 500kw for long and at that point you’re looking at an auto or dog engagement manual,  once you’ve gone dog engagement you may as well go sequential, they cost a little bit more but it’s worth it  also while you’re at it you should upgrade the transfer case with 10 friction plates 
×
×
  • Create New...